Frigidaire FKOF38MDIS Manual De Instrucciones página 28

cylinder from the regulator valve when
the grill is not in use. DO NOT obstruct
the flow of combustion air and
ventilation air to the grill. The propane
cylinder must be arranged for vapor
withdrawal and equipped with a listed
overfilling prevention device. Please
put the proper cylinder orientation to
provide vapor withdrawal.
Connection the Gas Cylinder
Always place the propane cylinder on
the tank brackets located on the right
side of the cart. Always confirm that
all burner control knobs are in the OFF
position before activating the gas
supply.
Before connection, be sure that there
is no debris caught in the head of the
gas cylinder, head of the regulator
valve, or in the head of the burner and
burner ports. Always connect the gas
supply regulator as follows: Insert the
nipple of the valve coupling into the
tank valve and tighten the connection
collar by turning it clockwise wit one
hand while holding the regulator with
the other hand (See diagram to right).
Disconnect the propane cylinder from
the regulator valve when the grill is not
in use.
Do not obstruct the flow of
combustion air and ventilation air to
the grill.
Keep ventilation openings of the
cylinder enclosure free and clear from
debris.
Place dust cap on cylinder valve outlet
53
Attention
Do not store a spare LP-gas cylinder
under or near this appliance.
Never fill the cylinder beyond 80
percent full.
If the information in (a) & (b) is not
followed exactly, a fire causing death
or serious injury may occur.
whenever the cylinder is not in use.
Only install the type of dust cap on
cylinder valve outlet that is provided
with the cylinder valve. Other types of
caps or plugs may result in leakage of
propane.
To prevent fire or explosion hazard when testing for a leak
1. Always perform the "leak test" as described below before lighting the grill or
each time the cylinder is connected for use.
2. Do not smoke or allow other sources of ignition in the area while conducting
a leak test.
3. Conduct the leak test outdoors in a well-ventilated area.
4. Do not use matches, lighters or a flame to check for leaks.
5. Do not use grill until any and all leaks are corrected. If you are unable to
stop a leak, disconnect the propane supply. Call a gas appliance service
shop or your local propane gas supplier.
To Perform a Leak Test
Make 2-3 oz. (0-90ml.) of leak solution by mixing one part liquid dishwashing
soap with three parts water in a spray bottle.
Spray solution on the tank valve to regulator connection.
Inspect the solution at the connection looking for bubbles. If NO bubbles
appear, the connection is secure. If bubbles appear, you have a leak.
Check the regulator connection as follows:
Disconnect regulator from the tank and reconnect, making sure the connection
is secure. Retest with solution. If you continue to see bubbles, replace the
cylinder.
Attention
Make sure control knobs are off.
Attention
Before starting the grill, check for
leaks. Make sure the regulator valve is
securely fastened to the valve
assembly tube and the cylinder.
54