Manual Defrost; Cleaning, Care & Maintenance - Polar GL001 Manual De Instrucciones

UK
Installation
Note: If the unit has not been
stored or moved in an upright
position, let it stand upright for
approximately 12 hours before
operation. If in doubt allow to
stand.
1. Remove the appliance from the packaging and
the protective film from all surfaces.
2. Avoid positioning the appliance in direct
sunlight or damp areas.
3. When positioning the appliance, maintain a
distance of 25cm between the appliance and
walls or other objects for ventilation. NEVER
LOCATE NEXT TO OR NEAR A HEAT
SOURCE.
4. Insert the slide-out shelf/shelves at the desired
levels and place the smaller shelf/shelves on
the floor of the appliance.
5. If necessary, adjust the screw feet of the
appliance to make it level.
Note: Before using the appliance
for the first time, clean the
shelves and interior with soapy
water.
Operation
Control Panel
The control panel is located below the doors on the
front of the appliance.
Cooling Light
Turn On
1. Close the door of the appliance.
2. Connect the appliance to a mains power
supply.
4
GL001-GL017_GE997-GE999_ML_A5_v7_20210127.indb 4 GL001-GL017_GE997-GE999_ML_A5_v7_20210127.indb 4
3. Turn the light switches On [I] or Off [O] as
desired.
Set the Operating Temperature
1. Press the
2. Press the
required temperature.
3. Press the

Manual Defrost

• POLAR Back Bar Chillers feature an automatic
defrost. However, should the appliance require
an additional defrost period press and hold the
• Automatic defrost cycles are every 6 hours and
last 20 minutes (factory defaults).
• To stop the Defrost press and hold the
Cleaning, Care &
Maintenance
Defrost Light
• Clean the interior of the appliance as often as
possible.
• Do not use abrasive cleaning agents. These
can leave harmful residues.
• Always wipe dry after cleaning.
• A POLAR agent or qualified technician must
carry out repairs if required.
Note: The Cooling Light is
illuminated when the appliance
is chilling the interior cabinet.
button. The display will flash.
or buttons to display the
button to store the temperature.
and button for 6 seconds.
button for 6 seconds.
Note: If a manual defrost is
started this resets the automatic
defrost timer. During defrost
periods the Defrost light is
illuminated.
Switch off and disconnect
from the power supply before
cleaning
and
2021/1/27 14:09 2021/1/27 14:09