Grinding/Cutting Disc; Rubber Sanding Pad - Bosch PWS 10-125 CE Instrucciones De Servicio

Grinding/Cutting Disc

Pay attention to the dimensions of the grinding
disc. The mounting hole diameter must fit the
mounting flange 8 without play. Do not use re-
ducer pieces or adapters.
When using a diamond cutting disc, take care
that the direction-of-rotation arrow on the dia-
mond cutting disc and the direction of rotation of
the machine (direction-of-rotation arrow on the
machine head) agree.
For mounting, see the illustration page.
Screw on the clamping nut 10 and tighten with
the two-pin spanner (see Section "Quick-clamp-
ing Nut").
8
If the O-ring is missing or is damaged, it must
in all cases be
1 600 210 039) before the mounting flange 8 is
mounted.
After mounting the grinding tool and be-
fore switching on, check that the grind-
ing tool is correctly mounted and that it
can turn freely.
Flap Disc
Depending on the application, remove the protec-
tion guard 6 and mount the hand guard 12. Place
the special mounting flange 8 (accessory, Order
No. 2 605 703 028) and the flap disc on the
grinder spindle 5. Screw on the clamping nut 10
and tighten with the two-pin spanner.

Rubber Sanding Pad 13

Depending on the application, remove the protec-
tion guard 6 and mount the hand guard 12.
For mounting, see the illustration page.
Screw on the round nut 15 and tighten with the
two-pin spanner.
18 • 1 609 929 F15 • TMS • 03.06.03
An O-ring (plastic
part) is inserted in
the mounting
flange 8 around the
spigot.
replaced (Order
Cup Brush 16/Disc Brush
Depending on the application, remove the protec-
tion guard 6 and mount the hand guard 12.
The grinding tool must be able to be screwed
onto the grinding spindle 5 until it rests firmly
against the grinder spindle flange at the end of
the grinder spindle threads. Tighten with an
open-end spanner.
Quick Clamping Nut
Instead of the clamping nut 10, the quick-clamp-
ing nut 11 (accessory) can be used. Grinding
tools can then be mounted without using tools.
The quick-clamping nut 11 may be used only
for grinding and cutting discs.
Use only a flawless, undamaged quick-clamp-
ing nut 11.
When screwing on, take care that the side with
printing does not point to the grinding disc. The
arrow must point to the index mark 21.
No.
11
4
4
English - 5
Lock
spindle with the spin-
21
dle lock
Tighten the quick-
clamping
forcefully turning the
grinding disc in the
clockwise direction.
A properly tightened
undamaged,
clamping nut can be
loosened by hand
turning the knurled
ring in the counter-
clockwise direction.
Never loosen a tight
quick-clamping nut
with pliers but use a
two-pin spanner. In-
sert the
spanner as shown in
the illustration.
the grinder
button 4.
nut by
quick-
two-hole