3M Peltor Serie Manual De Instrucciones página 66

CLEANING INSTRUCTIONS
1. At the end of each shift the cushions of the ear muffs should
be wiped with a suitable material, for example 3M™ 504
Cleaning wipes, so they remain clean and hygienic. The product
can also be cleaned using mild detergent and water.
2. If the ear muffs cannot be cleaned or are damaged, dispose
of the product and obtain a new pair.
3. Cushions and inserts can be replaced using the following
Hygiene Kits as shown below.
Remove the cushions and inserts as shown.
See Figure 10.
Replace the worn or damaged cushions and insert with the new
pair from the appropriate hygiene kit.
4. Replace the product within 5 years from the date of
manufacture or immediately if damaged.
NOTE
In addition to the hygiene kit shown, 3M™ Peltor™ HY100
sweat pads are also available that can be applied onto the ear
muff cushions to help absorb sweat and moisture for improved
comfort and hygiene.
Hygiene Kits
Ear Muff Model
3M™ Peltor™ H510 Series Optime™ I
3M™ Peltor™ H520 Series Optime™ II
3M™ Peltor™ H540 Series Optime™ III
3M™ Peltor™ H520 Series Bull's Eye™ II
3M™ Peltor™ H540 Series Bull's Eye™ III
3M™ Peltor™ H31 Series
MATERIAL LISTING
Headband Version
Headband/Neckband
Helmet Attachment Arm
Cups
Inserts
Cushions
Cushion Covers
Mass (g)
H510A = 180
H520A = 210
H540A = 285
H31A 300 = 190
H540P3E = 310
STORAGE AND TRANSPORTATION
Follow the manufacturers recommendation for storage.
Check packaging for further information.
{ Date of Manufacture
\ Temperature Range
} Maximum Relative Humidity
Always store the product in the original packaging and away
from any sources of direct heat or sunlight.
When stored ensure the headband is not stretched (applies to
headband/neckband versions) and the cushions are not
compressed as this may damage the product.
APPROVALS
These products meet the requirements of the European
Community Directive 89/686/EEC (Personal Protective
Equipment Directive) and are thus CE marked.
Hygiene Kit Model
Certi cation under Article 10, EC Type-Examination, has been
issued for these products by
HY51
INSPEC International Limited, 56 Leslie Hough Way, Salford,
HY52
Greater Manchester M6 6AJ, UK (Noti ed Body number 0194)
and Finnish Institute of Occupational Health (FIOH),
HY54
Topeliuksenkatu 41aA, FIN-00250 Helsinki, Finland (Noti ed
HY52GN
Body number 0403).
HY54GN
3M™, Peltor™, Optime™ and Bull's Eye™ are trademarks of
3M Company.
HY52
Headband/Neckband/Foldable Version
Stainless Steel wire, PVC, Acetal
ABS
Polyether
Polyether
Polyether and Glycerine
(H510, H520 and H31 Series only)
PVC
64
H510B = 165 H510F = 200
H520B = 195 H520F = 230
H540B = 270 H510P3E = 205
H31B 300 = 175 H520P3E = 235
H31P3 300 = 285
Helmet Mounted Version
Stainless Steel wire, Acetal, Polyamide
ABS
Polyether
Polyether
Polyether and Glycerine
(H510, H520 and H31 Series only)
PVC