Connecting A Vcr Or Standard Video Device - Insignia NS-LCD19W-09 Guia Del Usuario

Connecting a set-top box or satellite TV
#2
#1
To connect a set-top box or satellite TV
(alternative #1):
1 Connect the antenna cable from the set-top
box or satellite box to the ANT IN jack on the
back of your TV.
2 Turn on your TV and the cable or satellite
box.
3 Switch the channel selection to channel 3 or
4 on the cable or satellite box, then tune your
TV to the same channel.
4 Press INPUT repeatedly to select TV.
5 Change channels with the cable or satellite
box, or with the cable or satellite remote
control.
To connect a set-top box or satellite TV
(alternative #2):
1 Plug an RCA video cable into the cable or
satellite box and into the VIDEO IN (yellow)
jack on the back of your TV.
2 Plug the RCA audio cables into the cable or
satellite box and into the AUDIO IN R (red)
and AUDIO IN L (white) jacks on the back of
your TV.
3 Turn on your TV and the cable or satellite
box.
4 Press INPUT repeatedly to select Video.
5 Change channels with the cable or satellite
box, or with the cable or satellite remote
control.
To connect a set-top box or satellite TV
(alternative #3):
1 Use the following illustration to connect a
converter/descrambler box. (The RF switch
and the signal splitter are not provided.)
2 Set the RF switch to the A position to watch
unscrambled channels controlled by your TV
remote control.
- OR -
10
Set the RF switch to the B position to watch
scrambled channels controlled by the cable
or satellite box or remote control.
RF switch
TV
Connecting a VCR or standard video
device
To connect a standard video device to the
VIDEO IN jacks:
1 Plug an RCA video cable into a VCR or other
standard video source and into the VIDEO IN
(yellow) jack on the back of your TV.
2 Plug the RCA audio cables into the video
device's audio output jack and into the
AUDIO IN R (red) and AUDIO IN L (white)
jacks on the back of your TV.
3 Turn on your TV.
4 Press INPUT repeatedly to select Video.
To connect a standard S-Video device to the
S-VIDEO jack:
1 Plug an S-Video cable into the S-Video out
jack on an S-Video device and into the
S-VIDEO jack on the back of your TV.
2 Plug RCA audio cables into the S-Video
device audio output jacks and into the AUDIO
IN L and AUDIO IN R jacks on the back of
your TV.
3 Turn on your TV.
4 Press INPUT repeatedly to select S-Video.
www.insignia-products.com
Insignia NS-LCD19W-09 19" LCD TV
Two-set signal splitter
A
B
Out In
Cable converter/descrambler box