Preparation; Electrical Requirements - GE Zoneline AZ90 Serie Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Installation Preparation
Questions? Call 844-GE4-PTAC (or 844-434-7822 ) or
BEFORE YOU BEGIN
Read these instructions completely and carefully.
IMPORTANT –
instructions for local inspector's use.
IMPORTANT –
governing codes and ordinances.
Note to Installer –
instructions with the owner.
Note to Owner –
future reference.
• Proper installation is the responsibility of the
installer.
• Product failure due to improper installation is not
covered under the Warranty.
• You must use all supplied parts and use proper
installation procedures as described in these
instructions when installing this air conditioner.
IMPORTANT ELECTRICAL
SAFETY—READ CAREFULLY
WARNING
• All electrical connections and wiring MUST
be installed by a qualified electrician.
• Follow the National Electrical Code (NEC) and local
codes and ordinances.
• For personal safety, this Zoneline must be properly
grounded.
• Protective devices (fuses or circuit breakers)
acceptable for Zoneline installations are specified
on the nameplate of each unit.
• Do not use an extension cord with this unit.
• Aluminum building wiring may present special
problems—consult a qualified electrician.
• When the unit is not running there is still voltage to
the electrical controls.
• Disconnect the power to the unit before servicing
by removing the branch circuit fuses or turning the
circuit breakers off at the panel.
49-7769
Save these
Observe all
Be sure to leave these
Keep these instructions for
Visit our Website at:
ELECTRICAL
REQUIREMENTS
Wire Size
Use ONLY wire size recommended for
single outlet branch circuit
Fuse/Circuit
User ONLY type and size fuse or
Breaker
HACR circuit breaker indicted on units
rating plate. Proper over current pro-
tection to the units is the responsibilty
of the owner.
Grounding
circuit to unit, or through separate
ground wire provided on permanently
connected units. Be sure that branch
circuit is grounded.
Wire Sizing
Use recommended wire size given in
tables and install a single branch cir-
cuit. All wiring must comply with local
and national codes.
NOTE: Use copper conductors only.
NOTE: All field wiring must comply with NEC and
local codes. It is the responsibility of the installer
to insure that the electrical codes are met.
• Use ONLY the wiring size recommended for single
outlet branch circuit.
• Proper current protection is the responsibility of the
owner.
Recommended branch circuit wire sizes*
Nameplate
maximum circuit
breaker size
AWG – American Wire Gauge
NOTE: Use copper conductors only.
GEAppliances.com
AWG Wire size**
7

Publicidad

Tabla de contenido
loading

Tabla de contenido