Putting The Appliance Into Operation; After Use - Clatronic HS 2631 Instrucciones De Servicio

44084-05-HS 2631

Putting the Appliance into Operation

GB
1. Check whether the filter is inserted correctly on the front of the device.
2. Open the vacuum with the fastener (2).
3. Close the vacuum again by inserting the flap on the front in the relevant slot.
4. Close the vacuum by locking into place the upper flap.
5. Mount the desired accessory with or without the hose on the front of the vacu-
um. When using the hose make sure that the curved side is facing down.
Connect the device to a duly installed 230V, 50Hz protective contact socket.
To start the vacuuming, press only the On/Off (I/O) switch.
Since the device has a removable and washable filter, there is no need to buy
spare dust bags.
Nozzles:
Small brush nozzle: for the vacuuming of narrow surfaces and corners.
Large brush nozzle: for the vacuuming of large surfaces.
Hose with crevice nozzle: perfect for vacuuming the interior of cars.
These nozzles are perfect for furniture, upholstery, frames and plenty more.
Shoulder straps:
Hook the ends of the shoulder strap with the snap-link in the eyes (4 and 6). Make
sure that the shoulder straps are not wound up.
The length of the shoulder strap can be adjusted with the buckle on the strap by
simply pulling one side of the strap. Thanks to its light weight the hand vacuum can
be hung without problems and used anywhere.
1. Make sure that the vacuum is unplugged.
2. To clean the filter, press the button (2) to open the device.
3. Remove the filter and knock it. The filter can be cleaned under running water.
Do not use any aggressive or abrasive detergent. Make sure that the filter is
perfectly dry.
4. Mount the dust container again and close the vacuum as described in "Putting
the Appliance into Operation".
Always pull the plug out once you have finished using the vacuum. The vacuum can
be stored vertically without wasting any space.
This appliance conforms with the CE directives for radio interference suppression
and low-voltage safety and has been built to meet current safety requirements.
Subject to technical changes without prior notice!
24
02.10.2003 9:20 Uhr
Cleaning

After use

Seite 24