Triggered Burst - Aim TTi TG5011A Manual De Instrucciones

Triggered Burst

Each active edge of the trigger signal will produce one burst of the waveform.
Carrier Waveforms:
Maximum Carrier Frequency:
Number of Cycles:
Trigger Repetition Rate:
Trigger Signal Source:
Trigger Start/Stop Phase:
Gated
Waveform will run while the Gate signal is true and stop while false.
Carrier Waveforms:
Maximum Carrier Frequency:
Trigger Repetition Rate:
Gate Signal Source:
Gate Start/Stop Phase:
Sweep
Frequency sweep capability is provided for both standard and arbitrary waveforms.
Carrier Waveforms:
Sweep Mode:
Sweep Direction:
Sweep Range:
Sweep Time:
Marker:
Sweep Trigger Source:
Trigger Generator
Internal source 2mHz to 1MHz square wave adjustable in 1us steps, 9 digit resolution. Available for
external use from the SYNC OUT socket.
6
Sine, Square, Ramp, Arb, Pulse, PRBS
10MHz (finite cycles), 50MHz [25MHz] (infinite), subject to carrier
waveform.
1 to 16,777215 and infinite.
2mHz to 1MHz internal
dc to 1MHz external.
Internal from keyboard, trigger generator, or other channel.
External from TRIG IN or remote interface.
-360.0 to +360.0 degrees, 0.1 degree resolution, subject to carrier
waveform
Sine, Square, Ramp, Arb, Pulse, Noise, PRBS
10 MHz, subject to carrier waveform
2mHz to 1MHz internal
dc to 1MHz external.
Internal from keyboard, trigger generator, or other channel.
External from TRIG IN or remote interface.
-360.0 to +360.0 degrees, 0.1 degree resolution, subject to carrier
waveform
All standard and arbitrary except pulse.
Linear or logarithmic, triggered or continuous.
Up, down, up/down or down/up.
From 1µHz to 50MHz [25MHz], subject to carrier waveform. Phase
continuous. Independent setting of the start and stop frequency.
1ms to 500s (6 digit resolution).
Variable during sweep.
The sweep may be free run or triggered from the following sources:
Internal from keyboard, trigger generator, or other channel.
Externally from TRIG IN input or remote interface.