Warranty Disclaimer - Xavax 00111822 Instrucciones De Uso

G Operating instruction
Safety Notes
The product is intended for private, non-commercial use only.
Children are not permitted to play with the device. Children may not clean the product or perform user maintenance
without supervision.
Do not operate the product outside the power limits given in the specifications.
Never apply force when using the product or during installation.
Do not attempt to service or repair the product yourself. Leave any and all service work to qualified experts.
Do not open the device or continue to operate it if it becomes damaged.
Warning
Before carrying out the installation, it is imperative that you carefully read and follow the instructions provided by
the manufacturer of the appliance (refrigerator), in order to avoid damage to property through water leakage.
If necessary, check that your water pressure is below 100 psi / 7 bar (it is best to do this with the help of a
professional).
Get a plumber or an authorised installer to carry out the installation if necessary.
1. First, turn off the main water line and disconnect the refrigerator from the mains supply.
2. Pull off the retaining ring (C).
3. Lightly press the pipe connector (B) downwards and keep it pressed as you pull out the plastic bung (A). Repeat
the procedure on the other end of the filter. Note: if the pipe connector (B) is pulled out of the filter, it must be
reinserted.
4. Take the pipe for the ice maker (1/4 inch) and cut it straight with a knife. The cut must be square (90°), so that the
connection seals. Push the pipe firmly into the water filter as far as it will go (approximately 17 mm deep). Make
sure that you observe the water flow direction (FLOW è) displayed on the water filter!
5. Replace the retaining ring (C).
6. Turn on the water supply and check the complete system for leak tightness. Repeat the installation if necessary.
7. Flush the filter in accordance with the appliance manufacturer's guidelines (see operating instructions for refrigerator).
Note
Check the system 24 hours after installation. If you find dripping connections, repeat the installation steps for the
respective connection.

Warranty Disclaimer

Hama GmbH & Co KG accepts no liability for damages and consequential loss that arise from improper assembly or
failure to observe the assembly instructions. Do not use or continue to use crimped or damaged lines, connectors or
filters. If in doubt, commissioning should only be carried out by a qualified technician.
Technical Data
Operating temperature
0,6°C -38°C
2
Operating pressure
30 psi / 2 bar – 100 psi / 7 bar
Rated capacity
5000 l (1320 gallons)
Flow rate
2,5 l / min
0,66 gpm