D-Link DCS-6004L Guía De Instalación Rápida página 6

ADJUSTING VIEWING ANGLE
1
2 2
3
4
5
6
6
Step 1:
The camera housing needs to be separated from the camera base
to expose the screw used to adjust the viewing angle. Remove the
camera housing from the camera base by squeezing the housing
release buttons on either side of the camera.
Step 2:
Lift the camera housing up off the camera base once the housing
has been released.
Step 3:
Use a philips head screwdriver to loosen the retaining screw used to
secure the viewing angle of the camera lens.
Step 4:
Manually adjust the viewing angle back and forth to your desired
location.
Step 5:
Use a philips head screwdriver to tighten the retaining screw used to
secure the viewing angle of the camera lens.
Step 6:
Reattach the camera housing by lining up the housing so that the
access port on the housing matches the access port on the camera
base. Firmly push down until the camera housing snaps back onto
the camera base.
DCS-6004L / DCS-6005L