D-Link DAP-1522 Guía De Instalación Rápida página 4

TrOUBLESHOOTING
setuP AND coNFigurAtioN ProBleMs
1. HOW DO I CONFIGUrE MY DAP-1522 XTrEME N
POINT WITHOUT THE CD, Or CHECK MY WIrELESS NETWOrK NAME (SSID) AND
WIrLESS ENCrYPTION KEY?
- connect your pc to dap-1522 using an ethernet cable.
- open a web browser and enter the address http://dlinkap
- the default username is Admin. the default password is blank (leave this box empty).
- If you have changed the password and cannot remember it, you will need to reset the product
to set the password back to default.
2. HOW DO I rESET MY DAP-1522 XTrEME N
POINT TO FACTOrY DEFAULT SETTINGS?
- ensure the product is powered on.
- press and hold the reset button on the rear of the device for 5 seconds.
Note: Resetting the product to the factory default will erase the current configuration settings.
to reconfigure your settings, log into the dap-1522 as outlined in question 1, then run the
setup Wizard.
3. HOW DO I ADD A NEW WIrELESS CLIENT Or PC IF I HAVE FOrGOTTEN MY
WIrELESS NETWOrK NAME (SSID) Or WIrELESS ENCrYPTION KEY?
- For every pc that needs to connect to the dap-1522 wirelessly, you will need to ensure you
use the correct Wireless network name (ssId) and encryption key.
- use the web based user interface (as described in question 1 above) to check or choose your
wireless settings.
- make sure you write down these settings so that you can enter them into each wirelessly
connected pc. You will find a dedicated area on the back of this document to write down this
important information for future use.
4. WHY CAN I NOT GET AN INTErNET CONNECTION?
- For cable users, make sure that the Clone MAC address option is ticked during Wizard
installation (or enter the registered mac) and that your Isp username and password is correct.
4
DAP-1522_B1_QIG_v2.00(DI).indd 4
DUO WIrELESS BrIDGE/ACCESS
®
DUO WIrELESS BrIDGE/ACCESS
®
DAP-1522
2011/9/7 下午 02:16:15