Installation Diagram Of Indoor And Outdoor Units; Installation Space; Installation Place - Toshiba MMK-AP0073H Manual De Instalación

SMMS High-Wall Type

Installation diagram of Indoor and outdoor units

Before installing the
wireless remote
controller
1.Remove the battery
cover.
2.Insert 2 new
batteries (R03 [AAA]
type) following the
(+) and (–) positions.
Wireless
remote controller
Cover
Batteries
Batteries
Wireless remote
control

Installation space

The indoor unit shall be installed so that its top surface comes at a height of 2m or more.
Also it must be avoided to put anything on top of the indoor unit.
*1 Reserve space required to install the indoor unit and for service work.
Keep 110mm or more for clearance between top plate of the indoor unit and the ceiling surface.
*2 Provide a space as shown for service clearance for the cross flow fan.

Installation place

• A place which provides the spaces around the indoor unit as shown in the above diagram.
• A place where there is no obstacle near the air inlet and outlet.
• A place that allows easy installation of the piping to the outdoor unit.
• A place which allows the front panel to be opened.
• Direct sunlight to the indoor unit' s wireless receiver should be avoided.
• The microprocessor in the indoor unit should not be too close to RF noise sources.
(For details, see the owner' s manual.)
Hook
Pan head wood
screw Remote control
holder
CAUTION
– 6 –
Hook
For the rear left and left piping
Installation plate
Insert the cushion between the
indoor unit and wall, and tilt the
indoor unit for better operation.
Do not allow the drain hose to get
slack.
Shield pipe
Heat
Make sure to run the drain hose
insulator
sloped downward.
The auxiliary piping can be
connected to the left, rear left, rear
right, right, bottom right or bottom
left.
Right
Rear right
Bottom right
Installation Manual
Wall
Cut the piping hole
sloped slightly.
Left
Rear left
Bottom left
L
6-EN
EN