Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
ELECTRIC KETTLE
8
maximum of 1.7L). Never fill the water boiler over the "max". Otherwise
the hot water can spatter out of the base.
2. Refit the lid. Always fit the lid when boiling the kettle.
3. Put the power base on a stable, level surface.
4. Plug the power base into the wall socket.
5. Put the kettle on the power base
6. Move the switch to I.
7. The light will come on. The kettle will start to heat.
8. When the water boils the kettle will switch off.
9. To switch off manually, move the switch to 0, or simply lift the kettle off the
stand.
GENERAL
When you lift the kettle, you may see moisture on the stand. Don't worry – it's
the steam used to
switch off automatically, which then condenses and escapes via vents under
the kettle.
OVERHEATING SAFEGUARD
The jug kettle is fitted with an overheating safeguard. This will switch off the
jug kettle if it is operated without (sufficient) water. Allow the jug kettle to cool
down for at least 10 minutes before using it again.
CLEANING AND MAINTENACE
• Remove the plug from the wall socket, and allow the appliance to cool.
• Clean the jug with a damp cloth. Never immerse the appliance in water.
Never put the appliance in a dishwasher. Make sure that the electrical
connections do not become damp.
• If the interior of the jug has become severely discoloured, then the best way
to clean it is with a damp cloth and a little washing soda. After cleaning, rinse
the jug very thoroughly.
ATTENTION
• Never use corrosive or scouring cleaning agents or sharp objects (such as
knives or hard brushes) to clean the appliance.
• Before cleaning, make sure that the appliance is not connected to the power
supply and that it has cooled down.
DESCALING
This appliance is equipped with an integral heating element, and consequently
limescale will not be formed. Consequently you do not need to descaled the
Publicidad
Tabla de contenido
