Air Filter; Troubleshooting Guide - Technibel TAF 208 L Instrucciones De Uso

GENERAL MAINTENANCE:
All equipment must be properly maintained in order to provide optimum performance over time. Faulty maintenance can
result in the cancellation of the product guaranty. Depending on the products, maintenance operations consist in the
cleaning of filters (air, water), internal and external exchangers, casings, and the cleaning and protection of condensate
tanks. Treating odours and the disinfection of room surfaces and volumes also contributes to the cleanliness of the air
breathed by users.

5 - AIR FILTER

FILTER:
• If the air conditioner is to operate satisfactorily, the air
filter must be cleaned regurlarly. To do this, remove the
inlet grille at the bottom of the unit and proceed as
follows :
- Unlock the two clips (A) holding the grilleby rotating
them through a suarter turn using a screwdriver or
coin.
- Remove the grille by pulling it forward.
- Take out the filter and wash it in warm soapy water or
use a vacuum cleaner.
- Replace the filter behind the grille and refit the grille,
locking the clips by rotating them through a quarter
turn.

6 - TROUBLESHOOTING GUIDE

• If the air conditioner is not working properly, carry out the following checks before calling the After-Sales Department.
• If the problem persists, contact the dealer or the After-Sales Department.
PROBLEMS
• The air conditioner is not operating
at all (the fan never comes on).
• Insufficient cooling or heating.
• Compressor runs but soon stops.
A
POSSIBLE CAUSES
1 - Power cut.
2 - Circuit-breaker thrown or fuse blown.
3 - Line voltage too low.
4 - The switch is on "0" (off).
1 - Air filter dirty or blocked.
2 - Heat source or too many people in
the room.
3 - Doors and/or windows open.
4 - Obstacle in front of the air inlet or
outlet.
5 - The thermostat is set too high for
cooling or too low for heating.
6 - The manual reset safety thermostat
has tripped.
- Obstruction in front of condenser coil.
3
A
A
SOLUTIONS
1 - Restore the supply.
2 - Contact the After-Sales Department.
3 - Contact the After-Sales Department.
4 - Put the switch on "I" (on).
1 - Clean the air filter.
2 - If possible, eliminate the heat source.
3 - Close them to prevent outside air
entering.
4 - Remove the obstacle in order to
provide good air circulation.
5 - Set the temperature lower (or higher).
6 - Check that air circulates properly
inside the unit.
Reset the thermostat.
If the problem continues, consult the
After-Sales Service Department.
- Remove obstruction.
F
GB
I
E
D