Stacking The C•Control - Samson Audio C-control Manual Del Propietário

Stacking and Tilting the C•control
Stacking the C•control
You can stack one C control,
or any other Samson C Class
units, on top of each other by
simply lining up the bumpers.
Important Note: Important Note: When stacking
the C control, be sure that only
the bottom unit has the tilting
feet installed.
• Remove the bottom screw from right front bumper.
• Identify the right tilting foot by the locating "R" marking on the inside top.
• Position the angled foot under the right bumper as shown in the drawing.
Installing the Tilting Feet
N
You can install the tilting rubber feet included with
your C control so that you can set the unit at a com-
fortable operating angle on a workstation or desktop.
0 10
HEADPHONE
Follow the simple instructions below to install the tilt-
VOLUME
0
VOLUME
ing feet.
• Remove the bottom screw from right front
SPEAKER A
R
HEADPHONE
bumper.
• Identify the right tilting foot by the locating "R"
marking on the inside top.
• Position the angled foot under the right bum-
per as shown in the drawing.
• Use the included 4 x 10mm screw to attach the
foot.
• Repeat the steps above for the front left bum-
per.
SOURCE
2TK B
SOURCE
2TK B
CONTROL ROOM
MUTE
SPK B
0 10
10
VOLUME
SUB
SPEAKER B SPEAKER C
DESTINATION
OL
+6
MIX 2TK A
0 10
0
HEADPHONE
VOLUME
-6
0
VOLUME
2TK C
-18
-30
L R SPEAKER A
HEADPHONE
LEVEL
DESTINATION
OL
+6
MIX 2TK A
0 10
0
HEADPHONE
VOLUME
-6
0
VOLUME
2TK C
-18
-30
L R SPEAKER A
HEADPHONE
LEVEL
TALKBACK LKBACK
TALK TO
DIM
0 0 0 10 1 1
TALKBACK LKBACK LKBACK LKBACK
TALK TO
LEVEL
MIC MI
16
TALKBACK
CONTROL ROOM
DIM
MUTE
0 10 0 10
10
SPK B TALKBACK
VOLUME LEVEL
SUB
SPEAKER B SPEAKER C MONO MIC
CONTROL ROOM TALKBACK
MUTE DIM
0 10 0 10
10
SPK B TALKBACK
VOLUME LEVEL
SUB
SPEAKER B SPEAKER C MONO MIC
SAMSON
CUE
2TK
CONTROL ROOM
MATRIX
SAMSON
TALK TO
CUE
TALK TO
2TK
CONTROL ROOM
MATRIX
SAMSON
TALK TO
CUE
TALK TO
2TK
CONTROL ROOM
MATRIX