Electrical Safety; Double Insulation - Sandri Garden GI46EM TR Manual De Instrucciones

GB
BASIC SAFETY PRECAUTIONS
operator. Always make sure both hands
are in operating position, firmly on the
handlebars, before placing the machine on
the ground.
E19. Do not pull your machine towards you or
walk backwards when mowing.
E20. Walk, never run. Always walk, never run.
Always walk carefully on slopes.
E21. Always mow across the face or slopes,
never up and down. Exercise extreme cau-
tion when changing direction on slopes. Do
not mow excessively steep slopes and
always wear non-slip foot wear.
E22. Mow only in daylight or in good artificial light.
E23. Never use the mower without the grass-
bag in place.
E24. Check grass bag frequently for wear or
damage.
E25. Switch the motor off and wait until the blade
comes to a complete stop before removing
the grass catcher or unclogging chute.
E26. Disengage the self-proppelled mechanism
or drive clutch on units so equipped before
switching on the motor.
E27. Never attempt to make a wheel height adju-
stment while the motor is running.
E28. Do not switch on the motor when standing
in front of the discharge chute.
E29. Do not put hands or feet near or under rota-
ting parts. Keep clear off the discharge ope-
ning at ali times.
E30. If any strange vibrations are felt while using
the machine, switch it off, remove the plug
from the socket and immediately look for the
cause of the vibrations.
E31. The cutting edges of the mower blade are
sharp and can lacerate (cut) skin tissue.
Care should be taken when doing any repair
work on or around the mower blade. To
prevent injury, it is recommended that gloves
be worn or the cutting edge be wrapped
with newspaper or any other suitable
material when working on the blade.
10
E32. Do not use solvent or cleaning fluids to clean
your machine - use a blunt scraper to remo-
ve gras and dirt. Always disconnect from
the electrical supply betore cleaning.
E33. Store your machine in a dry place when not
in use, preferably out of the reach of
children.

ELECTRICAL SAFETY

E34. Your machine is designed for use on a.c.
(mains) electrical supplies only - do not
attempt to use on any other supply. Plug
your machine into a power point - not a light
socket.
E35.

DOUBLE INSULATION

Your machine is double insulated. This
means that all external metal parts are
electrically isolated from the power supply.
This is achieved by placing an extra
insulation barrier between the electrical and
mechanical parts. Double insulation means
greater electrical safety and obviates the
necessity of having the machine earthed.
E36. Always keep the electrical supply cable
away from the blades - be aware of its
position at all times.
E37. The extension cable should always be
secured firmly on the supporting hook
(situated at the top of the handlebar) to
prevent it from being damaged while the
mower is in use.
E38. Never carry your machine by the cable or
jerk the cable to separate the connectors.
Keep the cable away from heat sources,
oils or sharp edges. Check the condition of
your cable before use and do not use if
damaged.
E39. Your machine should always be switched
off at the electrical supply, before
disconnecting any plug and socket
connector, or extension cables.Before
leaving the machine, remove the plug from
the socket.