Long-Term Storage; Storage Procedure For 1 - 3 Months; Storage Procedure For Greater Than 3 Months; Winter Storage - Westinghouse Annovi Reverberi WP2700 Manual Del Propietário

MAINTENANCE

LONG-TERM STORAGE

WARNING
Never store a pressure washer with
fuel in the tank indoors or in a poorly
ventilated area where the fumes can
come in contact with an ignition source
such as a: 1) pilot light of a stove, water
heater, clothes dryer or any other gas
appliance; or 2) spark from an electric
appliance.
NOTICE
Gasoline stored for as little as 60 days can go bad,
causing gum, varnish and corrosive buildup in fuel
lines, fuel passages and the engine. This corrosive
buildup restricts the fl ow of fuel, preventing an engine
from starting after a prolonged storage period.
Proper care should be taken to prepare the pressure
washer for any long-term storage.
Storage Procedure for 1 – 3 Months
1. Clean the pressure washer as outlined in After
Each Use on page 37.
2. Add a gasoline fuel stabilizer to the fuel tank. Follow
the recommended procedure of the fuel stabilizer
manufacturer for correct amount of stabilizer to add.
Storage Procedure for Greater Than 3
Months
1. Clean the pressure washer as outlined in After
Each Use on page 37.
2. Drain all gasoline from the fuel tank as best as
possible.
3. Connect a hose to the water inlet fi tting and turn on
the hose.
4. Start the engine and allow the pressure washer to
run until all the remaining gasoline in the fuel lines
and carburetor is consumed and the engine shuts
off.
5. Clean the pressure washer as outlined in After
Each Use on page 37.
6. Change the oil (see Changing Engine Oil on page
32).
7. Remove the spark plug (see Spark Plug Maintenance
on page 35) and place about 1 tablespoon of oil
in the spark plug opening. While placing a clean rag
over the spark plug opening, slowly pull the recoil
handle to allow the engine to turn over several times.
This will distribute the oil and protect the cylinder wall
from corroding during storage.
38
8. Replace the spark plug (see Spark Plug
Maintenance on page 35).
9. Move the pressure washer to a clean, dry place for
storage.

WINTER STORAGE

1. Follow steps 1 through 11 in After Each Use on
page 37.
2. Store the hoses, spray gn and nozzle extension.
3. Disconnect the spark plug wire.
4. Connect a 3-foot (1-meter) section of garden hose
to the water inlet hose fi tting.
5. Using a funnel, pour 6 oz (177 mL) of RV antifreeze
into the hose.
NOTICE
Use only RV antifreeze. Any other antifreeze can
damage the pump.
6. Slowly pull the recoil handle several times, until
antifreeze comes out of the high-pressure fi tting of
the pump.
7. Remove the 3-foot (1-meter) garden hose.
8. Reconnect the spark plug wire.
9. Store the pressure washer in a clean, dry place.
Remove and Install the Pump – WP2700
1. Disconnect high-pressure hose and soap siphon
hose from pump.
N OTE: The pump mounting bolts also mount the
engine in place. Do not tip the unit or the
engine could be damaged when pump is
removed.
2. Remove the 3 mounting bolts and washers holding
the pump to the frame (see Figure 54).
3. Slide the pump down off of the crankshaft (see
Figure 54).