Publicidad
Idiomas disponibles
Idiomas disponibles
Instruction
1. Insert the charger into the AC or DC outlet.
2. Select the battery voltage according to the battery pack you are charging.
3. Select the charging current accordingly. It is recommended to choose a charging
current between 0.25xC - 1xC (C=Battery Capacity)
Example: Charge a 2.4V 1200mAh battery pack.
-Charge voltage: 2.8V
-Charging current = 1200mAh x 0.4 = 480mAh. Choose the 500mAh charging
current.
4. Connect the battery pack to the charger. The dual LED lights in red.
5. The dual LED lights in yellow to show the discharge process. It will automatically
switch to fast charging mode after discherge. The LED will then be in red again.
6. When the battery is full, the LED lights in green and this indicates the charging
process is completed.
7. Disconnect the battery pack from the charger.
8. Remove the charger from AC/DC outlet.
Caution: When the DC input voltage is in 12V, this charger can only charge 1-6
cells.
Warning
1. Use only with rechargeable Ni-Cd or Ni-MH battery packs.
2. If the external flexible cable is damaged, it shall be replaced by the manufacturer
or his service agent, or a similar person in order to avoid a hazard.
Technical Specification
• Input Voltage: 230VAC~50Hz / 12-24VDC
• Selectable Output Voltage:
- For 230VAC & 24VDC input:
2.8V(2 cells) / 5.6V(4 cells) / 7V(5 cells) / 8.4V(6 cells) / 9.8V(7 cells) /
11.2V(8 cells) / 14VDC(10 cells)
- For 12VDC input:
2.8V(2 cells) / 5.6V(4 cells) / 7V(5 cells) / 8.4V(6 cells)
• Selectable output current: 500mAh/1000mAh
EN
Publicidad
