Remote Control Layout; Installation Instructions - Vision AV-1000 Manual Del Usuario

REMOTE CONTROL LAYOUT

1. Reset tone settings
2. Input Selection
3. Volume Down and Up
4. Mute
5. Treble and Bass Tone Controls

INSTALLATION INSTRUCTIONS

Take the following steps to install this product:
1. Decide on placement. You should position the loudspeakers so that there is an even
coverage of sound in the room. Bear in mind the position of the closest power source
in the room which will need to be connected to the master speaker which contains the
amplifier.
The speaker cable provided is 5 metres long. If you choose to position the speakers further
apart this cable can be extended with unshielded speaker cable with a gauge of no less
than 0.75mm. NOTE: THE WARRANTY WILL BE VOID IF YOU USE UNSUITABLE SHIELDED
CABLE.
2. Attach the brackets to wall. Ensure you use fixtures which are rated to take the weight of
the speakers.
3. Fit the passive loudspeaker to the bracket via the top and bottom mounting points on
the loudspeaker chassis. The passive loudspeaker has only speaker terminals on the rear.
Connect the speaker cable to the speaker and run it to the position of the master speaker.
4. Fit the master loudspeaker. The slotted bracket allows the loudspeaker chassis to be pulled
away from the wall and turned 90° to access the rear panel. Run the input and power
cables to the master speaker. Ensure the power switch is turned off while connecting all
the cables.
Your active speakers are ready to use! Use the remote control to turn them on and make
adjustments.
4
1
2
3
4
5