Publicidad
Idiomas disponibles
Idiomas disponibles
FELLING
L ARGE TREES
(6 inches in diameter or larger)
The notch method is used to fell large
trees. A notch is cut on the side of the tree
in the desired direction of fall. After a felling
cut is made on the opposite side of tree,
the tree will tend to fall in the direction of
the notch.
NOTE: If tree has large buttress roots,
remove them before making the notch. If
using saw to remove
buttress
roots,
keep saw chain from contacting ground
to prevent dulling of the chain.
NOTCH CUT AND FELLING TREE
• Make notch cut by cutting the top of
the notch first. Cut through 1/3 of the
diameter of the tree. Next complete
the notch by cutting the bottom. See il-
lustration. Once the notch is cut, re-
move the wedge of wood from tree.
First cut
Final cut here
Notc
-_ ',<-
• After removing the wood from the notch,
make the felling cut on the opposite side
of the notch. This is clone by making a
cut about two inches
higher than the
center
of the notch.
This will leave
enough uncut wood between the felling
cut and the notch to form a hinge. This
hinge will help prevent the tree from fal-
ling in the wrong direction.
Hinge holds tree on stump and
helps control fall.
Opening
of felling
cut
Closing of
notch
NOTE: Before felling cut is complete,
use wedges
to open the cut when
necessary to control the direction of fall.
To avoid kickback and chain damage,
use wood or plastic wedges, but never
steel or iron wedges.
• Be alert to signs that the tree is ready to
fall: cracking sounds, widening of the
felling cut, or movement in the upper
branches.
• As tree starts to fall, stop sew, put it
down, and get away quickly on your
planned retreat path.
• DO NOT use your saw to cut down a par-
tially fallen tree. Be extremely cautious
with partially fallen trees that may be
poorly supported. When a tree doesn't
fall completely, set saw aside and pull
down tree with a cable winch, block and
tackle, or tracton
CUTTING A FALLEN TREE
(BUCKING)
Bucking is the term used for cutting a fall-
en tree to the desired log size.
_IkWARNING:
Do not stand on the
!og being cut. Any portion can roll caus-
ing loss of footing and control.
De not
stand downhill of the log being cut.
IMPORTANT POINTS
• Cut only one log at a time.
• Cut shattered
wood very carefully;
sharp pieces of wood could be flung
toward operator.
• Use a sawhorse to cut small legs. Nev-
er allow another person to held the leg
while cutting and never held the leg
with your leg or foot.
• De not cut in an area where logs, limbs,
and roots are tangled. Drag logs into a
clear area before cutting them by pulling
out exposed and cleared logs first.
BUCKING TECHNIQUES
_IkWARNING:
If
sew
becomes
pinched or hung in a log, den't try to force it
out. You can lose control of the saw result-
ing in injury and/or damage to the saw.
Stop the saw, drive a wedge of plastic or
wood into the cut until the saw can be re-
moved easily. Restart the saw and care*
fully reenter the cut. Do not use a metal
wedge. Do not attempt to restart your saw
when it is pinched or hung in a log.
Use a wedge to remove pinched saw
Turn saw OFF and use a plastic or
wooden wedge to force cut open.
Overcuttingbogins
on the top side of the
log with thebottom of the sew against the
leg. When overcutting use light downward
pressure.
Publicidad
