Installation - KS ALVA Guía De Instalación Y Mantenimiento

INSTALLATION

STEP 1 – REMOVE ALL MOUNTING HARDWARE
drill a hole in the deck or lavatory
according to the recommended hole
size.
Remove the nut, the disk and the
gasket from the base of the soap
dispenser body.
If your dispenser is supplied with
anti-rotation solution, drill an
additional hole for anti-rotation pin.
STEP 2 – INSTALLING THE SOAP DISPENSER
Place the soap dispenser body
along with the bottom ring into
the hole in the deck or lavatory.
1
slide the gasket, disk and nut
over the soap dispenser body
nipple and secure it.
Fix the bottle with bottle sup-
2
port to the desired location.
4
Recommended Hole sIZe
INSTALLATION
snap the soap pipe from the
3
dispenser body into the quick
connection fitting of the pump.
STEP 3 – CONNECTING THE POWER SOURCE
Remove the protective sticker
1
covering the sensor. Keep away
from the sensor range.
connect the motor connector to
its matching connector coming
from the electronic unit. Please
note that since the connector
2
is water proof, some friction
might apply.
o-RIng VIsIBle –
not connected PRoPeRlY
onlY tHe gRooVes aRe VIsIBle –
connected PRoPeRlY
5