Getting Started; Quick Start - GE GFW850 Manual Del Propietario E Instalación

Getting started

To reduce the risk of fire, electric shock, or injury to persons, read the IMPORTANT SAFETY
WARNING
INFORMATION before operating this appliance.
Throughout this manual, features and appearance may vary from your model.

Quick Start:

Step 1
Load clothes into your
washer and close the
door.
Step 2
If the screen is dark,
press the Power pad or
turn the knob to "wake
up" the display.
Step 3
Turn the knob to
select the desired
cycle.
(cycle options
vary by model)
Display and Status Lights
The display shows the approximate time remaining until the end of the cycle and the washer cycle status (Fill, Wash,
Rinse and Spin).
NOTE: The cycle time is affected by how long it takes the washer to fill. This depends on the water pressure in your
home. The "smart" timer "learns" the amount of time it takes to fill your washer and adjusts the total time accordingly.
If an out-of-balance condition is detected by the washer, the Spin light will blink during the remaining portion of the
cycle and will stay illuminated for a short time after cycle completion. When this occurs, the washer is taking actions
to correct the out-of-balance condition and complete the cycle normally. In some cases, the washer may not be able
to balance the load and spin up to full speed. If you notice the load is more wet than usual at the end of the cycle,
redistribute the load evenly in the wash tub and run a Rinse & Spin cycle.
In addition, the display will show:
Will allow your appliance to communicate with your smartphone for remote appliance monitoring,
(WiFi)
control and notifications. It stays lit whenever the washer is on and is connected. It will blink during the
commissioning process or if it loses connection to the network.
Venting Venting will blink to indicate that you can select the ULTRAFRESH VENT feature at the end of the cycle. It
then stays illuminated once selected until venting is complete.
The controls on the washer are locked when this icon is illuminated. You must press and hold the Control
Control
Lock pad to unlock the controls.
This icon will illuminate while the door is locked and will blink while the washer is in the process of pausing
Door
and then unlocking.
Auto, More, Less The SmartDispense will automatically dose detergent according to the weight and soil level of the clothes. You
(on some models) can adjust this feature to dose 40% MORE or40% LESS detergent or turn it OFF to manually dose detergent.
Tank Low Will display when the SmartDispense tank needs to be re-filled. Typically, this first lights up when there are
(on some models) approximately 8 - 10 loads of detergent remaining.
Loads Left Displays the estimated number of wash loads left for the amount of detergent in the SmartDispense tank.
(on some models)
49-3000217 Rev 2
Step 4
Open the dispenser and add
detergent, bleach and fabric
softener, as desired. Models
with SmartDispense™ only
require that you select the
SmartDispense pad once the
tank has been filled.
(Features and appearance will vary)
Step 5
Press Start to begin the
wash cycle. The machine
will weigh your clothes and
add the proper amount of
water. When the wash cycle
is finished, the door will
unlock.
Step 6
After the wash cycle
is completed and the
clothes unloaded, select
ULTRAFRESH VENT™ to
help eliminate the excess
moisture in your washer so
you can close the door.
5