Extel WECA 109058 Instrucciones De Uso página 31

Install the lock block and the internal block on the door using the neoprene flanges. Before
definitively tightening, make sure everything works freely and satisfactorily (and check the code and
the lock works properly before closing the door!)
Do not tighten excessively the flanges. This could damage the good operation of the lock.
h - Strike
Bolt
Dead bolt
The strike must be placed in a way that only the FLAT SECTION of the latch bolt can enter but not
the deadbolt.
When the door is locked, the deadbolt must stop on the strike to maintain its anti-burglar
function.
Once the correct position determined, draw the contour and use this mark to make a 1 mm flush
mounting. The strike must be aligned with the frame otherwise readjust with the drilling machine
or a chisel in order to install the bolt.
t
Now, fix the strike with just one screw; test the lock to see if it works properly and proceed to
possible adjustments if necessary. Then you can definitively fix the strike.
6EN