IMPORTANT NOTE FOR APPLIANCES CONTAINING LITHIUM-ION BATTERIES
1. PRIOR to using the unit for the first time, please charge fully the battery
2. Charge the battery regularly after each use. Don't wait until it is discharged!
3. DON'T allow the battery to discharge completely, otherwise it will lose 20% of its capa-
city or even be totally damaged! If the voltage becomes too low, the internal circuits are not
powered anymore and it will become impossible to recharge the battery!
4. If you don't use the unit for a longer period of time, it is recommended to charge it at 40%
of its capacity and check/charge it once per month.
The life time of the battery depends on the observance of these recommendations.
We cannot be held responsible for damaged batteries further to the non-observance of
OPERATING INSTRUCTIONS
7
1. ON/OFF switch: Set to ON to set the fixture on. The built-in battery will start charging automa-
tically and the battery charge indicators will light up to show the charge level of the battery. It
takes about 3 hours to fully charge the battery.
2. DMX IN: Connect the XLR lead to this socket and the other end to the DMX output of a DMX
controller
3. DMX OUT: Connect an XLR lead from the output of this fixture to the DMX IN connector of the
following fixture (master-slave connection)
4. POWER IN: Connect the supplied mains lead to this socket and the other end to a suitable mains
outlet
5. POWER OUT: Connect a power lead to this socket and the other end to the POWER IN connector
of the following fixture (up to 4 fixtures)
6. Display with function buttons and battery charge indicators
7. Safety hooks for additional safety rope (not included)
REMOTE CONTROL
INSERTION OF THE BATTERY IN THE REMOTE CONTROL
Pull out the battery compartment and insert a button cell (CR2025 3V)
with the positive side facing upwards. Push in the battery compartment
until it clicks into place.
EN
4
** BATTERIES ARE NOT COVERED BY THE WARRANTY **
these basic rules.
4
5
2 3
1
OFF/ON
© COPYRIGHT LOTRONIC 2020
6
7