Tristar ST-8910 Manual De Usuario página 5

To turn the unit off and hold the left button for several seconds until you hear a soft signal, the
display turns off. Unplug the power cord and let it completely cool before you pick up the
appliance. There may be condensation on the iron occur, this is normal. Make iron dry with a
soft cloth. You need the base to empty before storing.
If the steam button longer than 15 minutes is not pressed the device will disable in sleep mode,
you hear a soft tone, the display is black and AUTO OFF appears in the display, as shown in
the picture.
Press the right or left button to the system to switch on.
THE USE OF YOUR SYSTEM WITH STEAM
The control device is always at maximum steam power enabled
1. Set the switch on the iron to the desired position. From MIN to MAX. On the label in your
garment, you can find the correct position for the garment is appropriate, see the table, the
meaning of the standings.
2. Press the steam switch on the iron in. When the desired temperature is reached, the control
light on the ironsole will go off.
.
MAXIMUM steam.
Press the right button once
MEDIUM steam power
Press the right button twice
MINIMUM steam power
Press the right button three times for
disabling steam use.
The steam not use character in the display.
GARMENT FABRIC THERMOSTAT
LABEL TYPE REGULATION
·
Synthetic low
temperature
··
silk –
medium
wool
temperature
···
Cotton
high
– linen
temperature
Fabric not to be ironed
THE USE OF YOUR SYSTEM WITHOUT STEAM
Press three times on the right button to turn off steam use.
The steam not use character in the display.
Set the switch on the iron to the desired position. From MIN to MAX. On the label in your
garment, you can find the correct position for the garment is appropriate, see the table, the
meaning of the standings.
CLEANING YOUR SYSTEM.
•
Turn the base next to the sink in the kitchen.
•
Fill the reservoir with cold tap water.
•
Set the temperature knob to the MIN setting.
•
Turn the unit on and wait until the device is ready for use.
•
Hold the iron over the sink and hold the steam button
three minutes down. Please note that you or others can come into contact with
the hot steam, this can cause injuries.
•
The steam holes are cleaned.
•
Turn the temperature knob to the MAX setting
•
Remove the iron dry with a soft cloth. Note the sole iron is hot!
•
You need the base to empty before storing.