Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Appliance assembly
WARNING: After having removed the appliance from its package, before using it for the first time, thoroughly wash
all parts that will come into contact with food using water and mild soap.
•
Put the motor base (M) onto a stable, flat surface. Make sure the surface is easily accessible.
•
Place the bowl (F) onto the base (M) and rotate it clockwise until a click is heard (Fig. 2).
•
Put the filter holder (E) into the bowl (F) (Fig. 3).
•
Insert the filter (D) into the corresponding filter holder (E), making sure the two references on the bowl (F) and on the filter
itself (D) are aligned (Fig. 4).
•
Put the pressing screw (C) inside the filter (D), by rotating it until it is properly positioned in the filter (Fig. 5).
•
Position the lid (B) onto the bowl (F) by ensuring it is properly inserted on the upper pin of the pressing screw (C). Rotate it
anti-clockwise so that the side tab fits perfectly in the corresponding motor base slot (M) (Fig. 6).
•
Put the container (I) underneath the juice dispensing spout (G) (Fig. 7).
•
Place the pulp container (N) underneath the ejecting spout (O) (Fig. 8).
•
Put the food previously prepared into the related housing on the lid (B) and position the food presser (A) close to the hous-
ing itself (Fig. 9).
WARNING: The filter (D) has small sharp blades for chopping food. Be careful not to get hurt while removing
or cleaning the filter.
Should the lid (B) and the bowl (F) be mounted improperly, the juicer does not start. In this case the motor
does not run, even though the switching on button (H) is in "I" position. Make sure all components are properly
mounted before use.
Switching on
•
Plug in appliance.
•
Position the switching on dial (H) to "I". The motor start running. Open the cap on the juice dispensing spout (O).
•
Let the food presser (A) slide in the corresponding housing on the lid (B) and slightly press to bring food towards the filter
(D). Do not put too much food into the appliance and do not excessively press on the food presser (A).
•
By rotating the switching on button (H) to "II", the motor changes direction of rotation for a better juice extraction.
ATTENTION: Do not press quickly the switching on button (H) from "I" to "II", but remain in "O" position for
few seconds.
WARNING: This appliance is not designed to work in a continuous mode. Let the motor cool down after 2 minutes
of continuous functioning.
•
Once having processed the first load of food, repeat the above steps to make some other juice, otherwise remove the
container.
•
To make sure the appliance goes on working properly, prevent the pulp container (N) from being overfilled. Empty the
container, if necessary:
Switch the appliance off, by bringing the switching on button (H) to "O, and then unplug it.
9
Carefully remove the pulp container (N) from under the related spout (O).
9
Carefully empty the pulp container (N) and place it back under the related spout (O).
9
NOTE: To make pulp container cleaning easier (N), put a plastic bag into the container itself. This operation is
also useful to prevent the pulp from splashing out of the container rim.
•
After use, switch the appliance off, close the cap on the juice dispensing spout (G), disconnect the power plug and remove
the container (I) to serve the juice.
•
Keep the juice in the fridge by covering the container (I).
WARNING: Use the juice in the fridge within 24 hours.
•
Clean immediately after use
OPERATING INsTRUCTIONs
- 10 -
Publicidad
Tabla de contenido
