Network Setup - Honeywell TG-IP1-SEC Guia De Instalacion

Serial Device Server
4.1 Device Monitor
The TG-IP1-SEC incorporates a monitoring page that allows to check the device operation in a remote way.
This page shows the communications status (Serial port activity), and the average Power Supply voltage.
At the bottom of the page there is a window (Communications Monitor) where the protocol frames that are communicating
through the TG-IP1-SEC will be shown, indicating their direction as well as a counter shows the communications advance.
[-1715430728] UDP>RS232: :S083.
[-1715643559] RS232>UDP: ;S083.
Consider that the data traffic shown is only a reference and doesn't show in an exact way the transmitted protocol.
This window can also shows some error conditions, as for example, that the host configuration for the serial port is missing.
[-1551902493] Error-UDP: Host 192.168.0.50 no configurado.

4.2 Network setup

The TG-IP1-SEC communication parameters through the Ethernet Network are configured on this chapter.
(The adjustments about RS232 port are done in the 'UART Configuration chapter').
Network setpup – UDP Configuration
IP Address Device IP Address, 192.168.1.253 by default.
Subnet mask Subnet mask for the configured IP.
Gateway Gateway IP address to communicate with other Networks.
UPNP Identifier Device identifier text in the network 1
Encryption enable Enables or disables the encrypted communications option.
Key(PSK) Sets the desired encryption Pre-Shared-Key.
Repeat Key(PSK) Sets the desired encryption Pre-Shared-Key, for dialog validation.
1 This feature requires activating the functionality UPnP in your network system and PC device.
TG-IP1-SEC_User Manual
TG-IP1-SEC
10 HLSI_MN-DT-1412_01 - Oct. 2017