Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
English
ASSEMBLY AND OPERATION
APPLICATIONS
Use as a drill
Drilling of soft steel, wood, plastic and aluminum materials.
Use as a screwdriver
Tightening and loosening of machine screws, wood screws and tapping screws.
REMOVAL AND INSTALLATION METHOD OF BATTERY
Insert
Pull out
Fig. 3
CHARGING METHOD
NOTE: Before plugging into the receptacle, make sure the following points.
The power source voltage is stated on the nameplate.
The cord is not damaged.
WARNING:
Do not charge at voltage higher than indicated on the nameplate.
If charged at voltage higher than indicated on the nameplate, the
charger will burn up.
Battery
Fig. 4
12
All manuals and user guides at all-guides.com
How to install the battery.
Switch
Align the battery with the groove in tool
Trigger
handle and slip it into place.
Always insert it all the way until it locks in
Handle
place with a little click, If not, it may acciden-
tally fall out of the tool, causing injury to
Latch
you or someone around you. (Fig. 3)
How to remove the battery.
Push
Withdraw battery from the tool handle while
pressing the latches on the sides of the
battery. (Fig. 3)
Battery
1. Insert the plug of battery charger into
the receptacle.
When the plug of battery charger has been
inserted into the receptacle, pilot lamp will
blink in red. (At 1-second intervals)
Pilot Lamp
WARNING:
Do not use the electrical
cord if damaged. Have it
repaired immediately.
Publicidad
Tabla de contenido
