Using The Radio; Using The Aux Input - ION JOB ROCKER Guia De Inicio Rapido

Rear Panel
1. Power Cable Input: Insert the included power cable here to
charge the unit. Note that the Job Rocker can run off the power
cable while it simultaneously charges the battery. The charge
indicator illuminates when the battery is charging.
2. AC Power Outlet: Flip open the rubber plugs and connect your
devices here. The AC outlets work when wall power is connected.
3. Fuse Cover: If the unit's fuse is broken use a screwdriver or
other tool to lift this tab to replace the fuse. Replace it with a fuse
with an appropriate rating.
Fuse model and type: US Units: 250V, 750 mA; EU/UK Units:
250V, 500 mA. Using a fuse with an incorrect rating can damage
the unit and/or fuse.
4. Power ON/OFF Switch: Turns Job Rocker on or off. Please note that while Job Rocker is connected to
a power source, it does not need to be powered on to charge the battery.
5. Battery Level Indicator: While the unit is powered ON and unit is not plugged in, these four lights
indicate the power left in the battery. Battery life varies based on volume and usage.
Connecting with a Bluetooth Device
1. Turn on Job Rocker using the power switch.
2. Navigate to your Bluetooth device's setup screen, find "ION Speaker" and connect.
3. If your device requires a passcode or PIN, enter "0000".
Note: The next time you approach Job Rocker with your Bluetooth device, it will automatically re-
connect.
4. If your Bluetooth device is not able to connect to Job Rocker, press the Bluetooth Disconnect button on
Job Rocker to break previous Bluetooth connections and reset the Bluetooth module.
Note: Maximum range will be achieved when using devices with Bluetooth 4.0.
5. Paired LED will light up solid when it is 'paired'.
6. Start playback from your Bluetooth device.
7. To connect to another Bluetooth device, press the Bluetooth Disconnect button. Repeat Step 2.
8. To disconnect a connected Bluetooth device, press the Bluetooth Disconnect button.
Note: If you experience trouble connecting or playing music, update your device's OS.

Using the Radio

1. Turn the radio on using the Radio Selector switch to select either AM or FM.
2. Use the Tuner buttons to search for a radio station. To "Seek" (jump to the next available station), hold
a Tuner button down for a few seconds until it starts to seek a station. The unit will remember the last
station you were on and start at that station when you power off and power on again.
To add a preset:
A. Select either the AM or FM band and then use the Tuner buttons to select the desired radio station.
B. Press and hold a numeric Radio Preset button for a few seconds to assign the current station to
that preset number. To use an added preset, tap a Radio Preset number once lightly to go to the
stored radio station.

Using the Aux Input

Connect your iPod, iPod touch, iPhone, smartphone, MP3 player, or similar device to the Aux input. Adjust
the output volume on your source device and then adjust the overall volume using the Volume knob on Job
Rocker.
Troubleshooting
If the sound is distorted: Try lowering the volume control of your sound source or musical instrument. Also, try to
reduce the overall volume of Job Rocker.
If there is too much bass: Try adjusting the tone or EQ control on your sound source to lower the bass level. This
will allow you to play the music louder before clipping (distortion) occurs.
If there is poor AM reception: When you have a Bluetooth device that is connected, disconnect your Bluetooth
device in order to listen to AM radio. To adjust AM reception, move the entire unit.
If the AC Outlet is not working: Make sure Job Rocker is connected to wall power.
If Job Rocker is not charging: Make sure the fuse is not blown. If it is, replace the fuse with one of the same rating.
5
5 2 2
1
4
3