Cisco 350X Serie Guia De Inicio Rapido página 10

Stacking the Cisco 350XG Series Switches
Before configuring the switches as a stack, refer to the Administration
Guide for additional details. Refer to the front panel graphics in
350X Series Switch Features
supported modules.
By default, the ports on a switch function as regular Ethernet ports, except
if you configure them to do stacking. You cannot mix the stack speeds
between the switches or ports.
Stack ports must be either configured with the same port
W
ARNING
speed or have the same speed capability on the module or
cable plug in. If the port speed is configured as auto, then the
module plugged into these two ports will need to have the
same speed capability, otherwise the switch will not be able to
form as a stack with multiple units.
A stack can have up to four Cisco 350XG series switches in it. Any 10G
port of the switch can be used for stacking. The switch can only be
stacked without Mesh topology.
The switches in the same stack are connected together through their stack
ports. Depending on the type of stack ports and the desired speed, you
may need Cat6a Ethernet cables and/or Cisco approved modules or
cables for the Cisco 350XG switches.
10
to help with the stack port descriptions and
Cisco 350X Series Managed Switches
Cisco