Before First Use - Proline BLEND30 Manual De Instrucciones

BEFORE FIRST USE

Carefully unpack the multi blender set and remove all packaging materials.
Check the contents to ensure that all of the accessories are present and not damaged.
Wipe the motor base with a damp cloth. Do not immerse it in water.
Wash all of the accessories in warm soapy water. Rinse and dry thoroughly.
Use extreme care when handle the blade attachments. Failure to do so could result in
personal injury.
OPERATION
The multi blender set is an extremely versatile blending and chopping set which can be
used for basic kitchen tasks such as chopping onions, garlic or grating cheese, whipping
cream or making smoothies.
Warning: Do not operate this appliance for more than 1 minute without interruption. Allow
it to cool for at least 2 minutes before operating it again.
Ensure that the appliance is unplugged from the mains socket.
Using the Blender Attachment and Filter
1. Place the motor base on a flat, stable surface.
2. When using the blender attachment, select the required flat or cross blade attachment
and twist it onto the bottom of the jug.
• The cross blade attachment is ideal for chopping, grating or blending and the flat
blade attachment is ideal for whipping cream or grinding coffee or sugar cubes.
3. Fasten the assembled blender attachment onto the motor base by turning the blender
attachment anticlockwise.
• Make sure that the three tabs on the outside of the blender attachment are aligned
with the three notches on the inner edge of the motor base.
4. Chop the ingredients to be blended into small pieces and then place them into the
blender attachment.
• Never overfill the blender attachment jug. Do not exceed the MAX line.
• Warning: If blending liquid, do not fill the blender attachment to more than ¾ of
the capacity.
• Warning:Never operate the blender attachment when the jug is empty.
5. If using the filter, push the filter all the way down to the bottom of the
blender attachment.
• Make sure that the three notches of the filter are aligned with the
ribs on the inside of the blender attachment.
6. Fasten the blender attachment lid on the jug.
• Either the straining pourer or regular pourer on the blender
attachment lid shall be aligned with the spout of the lid.
7. Fix the inner cap to the blender attachment lid by turning the inner
cap anticlockwise.
• Make sure the two tabs on the inner cap are aligned with the two
grooves on the inner edge of the blender attachment lid.
8. Plug in and switch on the appliance.
• During blending, you may add more ingredients by removing the inner cap and
dropping ingredients.
Replace the inner cap after adding ingredients.
• Use the plunger if necessary to push down the ingredients further into the
blender attachment.
9. Once the ingredients have been blended to the desired consistency, turn the blender
5