CONTROL PANEL
DISTANCE
SPEED
SCAN
POWER
SPEED -
OPERATING INSTRUCTIONS
1.Connect the power plug, place the magnet device
emergency in place in the control panel (page 5, Figure 6) and press
the power switch located on the lower rear of the machine.
(Behind the basis of the tape). The display will light up and emit 5 beeps
and the display shows "= = =". Press the power button panel
control
2.When you press the button on the control panel the machine
begin to run until after 3 seconds shown on the screen,
order to be able to prepare for use, these three seconds after the tape
starts moving and the machine goes into sleep mode the speed display
screen. The initial value of speed is 1 and can be changed from 0.1 in
0.1 up to 10 km / h speed + pressing the button, if you want lower
speed speed presses the button - will be reduced from 0.1 to 0.1 in
desired speed, press these buttons to change the
speed + or - as desired. To change the mode shown in
screen and see the other options according to press the Mode button panel
control, it will change according to press to see the speed, time,
distance and calories, go pressing the button and a light will indicate what
shown on the display (speed, time, distance and calories). If you press the
Scan button will change the information automatically so each
5 seconds to show all the information on speed, time, distance and
calories every 5 seconds without pressing any function button.
3.When the tape is running by pressing the button on the panel
control the engine will slow down to a stop.
TIME
CALORIES
MODE
DISP.SEG.
SPEED +
In the following cases the guarantee will not be effective:
a.Cualquier damage resulting from any repair or manipulation
authorized by the company.
b.Cualquier damage resulting from misuse, negligence or accident.
c.Cualquier damage caused by natural disasters or abnormal voltage.
d.Cualquier damage resulting from use cases in other machine
contexts other than described in this manual.
14
PANEL CONTROL
SECURITY
HAND RAIL
RUNNING BELT
15