Technical Features; Default Values - CDVI DGPROX Manual De Instrucciones

Edición 03/2018

Technical features

Input voltage
Output
Anti-triggering contact
Badge entry
PIN Code
Master code
Input
Keyboard
Distance between the
second reader and the
DGPROX unit
Warning: Do not use a switching power supply because of radiation interference,
which may disturb the reading of the badges.
.

Default values

Master code:
Door release time :
Key-in keypad:
Alarm:
Audible Signals
1 beep (long)
2 beeps
(short)
4 beeps
(short)
Visual Signals
LED color
Green
Red
Orange
Orange flashing
Request-to-exit
The request-to-exit push button PB1 operates relay RL1.
The LED turns green when the relay is activated.
12 VAC/DC
1 relay, N/O & N/C contact and 1 relay N/O contact 3A
/125V
500 mA 50 V ~ or =
500 programmable badges
500 programmable codes, 5-digit PIN code
5-digit programmable code
1 request-to-exit
12-digit keypad with built-in buzzer (audible signal)
minimum 24 inches (60 cm)
maximum
(cable minimum 7 x 0.6 mm
12345
1 second
10 seconds
Off
Validation of data in programming mode: master code, proximity
badge or time.
Or access code validated
Accessing the programming mode
or exiting from the programming mode
incorrect mode, user number and time outputs entered
Normal mode
Door relay activated
Alarm relay activated
Stand-by
45 yards
2
)
Programming mode
Code/Badge position
empty
Code/Badge position
busy
Programming mode
Data computing error
(50 meters)
9