Mounting Instruction - CDVI DGA Manual De Instrucciones

INSTALLATION MANUAL
DGA
Cast aluminium Digicode
4] MOUNTING KIT
05D 680K
DGA

5] MOUNTING INSTRUCTION

Once you have made sure that the mounting kit is complete and that you prepared the cables
of the DGA keypad then you can proceed and mount the product. Make sure that you have
all the appropriate tools (drill, screw drivers and a meter tape...) and follow the mounting
instructions of the DGA keypad.
1
Take the marks with the back plate
of the DGA. Drill the 2 mounting
holes (Ø 5 MM bit and 35 MM depth
minimum) and the wiring access
hole.
Self Contained
®
Spanner
for Torx
Varistor
T20 screws
1 1
2
Insert the 2 plastic anchors. Then
mount the back plate of the DGA
keypad, and screw on the wall with
the (M4x30) mounting screws.
Insert the cable of the keypad in
the wiring access area.
Place the keypad on the back plate
top first and then make sure that it
fits all over the back plate.
M4x10
®
Torx screw
®
1
(X2)
(X2)
S5 plastic
M4x30
anchor
screws
2 2
3
Digicode
fasten the screw at the buttom
of the DGA keypad with the Torx
screw using the spanner.
cdvigroup.com
EN
®
17