Work Pro DMX AIR MK II Manual De Uso

1. SAFETY INSTRUCTIONS
- CAUTION! Be careful with your operations. with a dangerous voltage you can suffer a dangerous
electric shock when touching the wires!
- This device has left our premises in absolutely perfect condition. In order to maintain this condition
and to ensure a safe operation, it is absolutely necessary for the user to follow the safety
instructions and warning notes written in this user manual.
- Important: damages caused by the disregard of this user manual are not subject to warranty.
- Keep away from heaters and other heating sorces!
- If the device has been exposed to drastic temperaure fluctuation (e.g. after transportation), do
not switch it on immediately. The arising condensation water might damage your device.
- Leave the device switched off until it has reached room temperature.
- If the external flexible cable or cord of this luminary is damaged, it shall be exclusively replaced
by the manufacturer or his service agent or a similar qualified person in order to avoid hazard.
- Always disconnect from the mains, when the device is not in user or before cleaning it.
- Keep away children and amateurs from the device.
- There are no serviciable parts inside the device. Maintenance and service operations are only to
be carried out by authorized dealers.
2. OPERATIONS
1. Connect a DMX Controller to the DMX input on the device used as transmitter
2. Connect your Fixture to the device used as receiver
3. Please turn on DMX controller and the luminaire, then start the wireless controller (Transmitter)
The receiver must be in off state.
4.When the register LED of Transmitter are in slowly strobe status, please press the register
button making the register LED strobe quickly,
- Now, start the Receiver immediately, at this time, the register LED of Receiver will enter the
quickly strobe status.
- Then they will match with each other. After 18 seconds, the register LED of Transmitter and
Receiver will strobe slowly,
- At the same time they connect successfully and control the luminaire by the controller.
5. When you need Transmitter connect much more Receivers, you only press the button on the
Transmitter, the register LED of Transmitter enter strobe quickly status,
- Then connect and turn on the Receiver (R1, R2, R3, etc). Please make again step 2.
SPECIFICATIONS
Suitable for
Voltage Input
Consumption
Frequency Band
Channels
RF channel data rate
DMX AIR MK II
Indoor use: IP 20
AC 100-240V, 50 Hz
2W max.
2400 to 2483 MHz
13 channels
250 Kbps
1
RF transmitter power
RF receive sensitivity
Antenna
Dimensions
Weight
User Manual/Manual de Uso
(Emitter/Transmitter)
18 dBm
-90 dBm
SMA.50 5%
250 x 250 x 350 mm
360 g
DMX AIR MK II
EN