Mark AMC 45 Manual De Uso página 7

A) SELECT FREQUENCY CHANNEL (0-99): In POWER ON state, press W/M CHANNEL
SELECT knob more than 3 seconds to wait for the number above the W/M1 CH in the right
corner of the LCD screen is flashing, during its flashing, turn the W/M CHANNEL SELECT knob
clockwise or counterclockwise to select the desired channel number from 0 to 99, then wait for
its stop flashing. At this time, the channel is selected.
B) MATCH FREQUENCY NUMBER (0-99). After point A, Press the W/M CHANNEL SELECT
knob again, the W/M1 CH and W/M1 VOL are flashing, at this moment, open the wireless
microphone battery cover and place its infrared transmitter near infrared reciever in the amplifier
(see picture) till the W/M1 CH and W/M1 VOL stop flashing. Then, the amplifier and the
microphone are matched
8. Dynamic microphone input connection (jack 1/4"). Its volume can be adjusted
with knob (5).
9. AUX input connection (minjack 3.5 mm). Its volume can be adjusted with
knob (5).
10. AUX output connection (minjack 3.5 mm).
11. SPEAKER OUTPUT 8Ω (RCA). This jack allows to connect an additional
loudspeaker for, p.e., monitoring purpose.
12. DC 12V/ 2.5A input jack. For external supply
13. CHARGE LED. This LED will lit in red during built-in li-ion battery charging
process.
14. INFRARED UHF wireless frequency transmitter
15. SD Card slot
16. USB port
.
Infrared receiver in the amplifier for auto matching the
UHF frequency number (0-99)
Infrared transmitter inside the microphone for auto
matching the UHF frequency number (0-99)
PAG. 6
User Manual/Manual de Instrucciones
EN
AMC 45