Pur Line HOTI M100 Manual De Usuario página 16

2. Press "MODE" button, the device will blow warm air and lights is on.
3. Press again "MODE" button, the device will blow hot air and light is on.
4. Press "MODE" button third time, the device will blow cold air.
For the "smart" function, press the power button near the main switch on the back of the device, the heater will
operate with hot air and the indicator will light up.
3) 24H TIMER
1. Switch on the appliance in any mode (fan, 1000W heating or 2000W heating).
2. Press the button "24H" to set the timer. Continue pressing "24H" button to increase the hours from 00--24,
the indicator lights up.
Note: "00" means no timer, indicator is off.
4) THERMOSTAT (only by remote control)
1. Switch on the appliance in any mode (fan, 1000W heating or 2000W heating).
"+"
-
2. To adjust temperature, press o " " , to set the desired temperature, from 10ºC to 49ºC.
3. When the air temperature drops 2 degree below the set temperature, the heater will start heating with
"I/W"(1000W).
4. When the air temperature drops 4 degree below the set temperature, the heater will start heating with "II/H"
(2000W).
5. When the air temperature is 1 degree more or equal to the set temperature, the heater will blow cold air.
5) OPEN WINDOW DETECTION (only by remote control)
1. Switch on the appliance in any mode (fan, 1000W heating or 2000W heating).
2. Press "AUTO" button, light is on and the device operates with an smart energy saving mode. (In this
function, the device is checking and recording the ambient temperature, it will stop to function when the
ambient temperature is detected to drop ≥ 3ºC within 1 minute. The user should restart the appliance with
"ON/OFF" button).
3. Press "AUTO" button again, light is off. Open Window Function is turned off.
6) CHILD-LOCK function (only by remote control)
1. This function can be used in any mode.
2. Press the "LOCK" button, the indicators and the LED display are off, only the "Power" indicator is on. Neither
the control panel nor the remote control can operate the device.
3. Press the "LOCK" button again, all the indicators will be on and both the control panel and the remote control
can operate the device.
14