Wireless Regulatory Information; Fcc Statement; Industry Canada Radiation Exposure Statement; Mexico Regulatory Statement - Linksys MAX-STREAM EA9300 Manual De Instrucciones

Wireless Regulatory Information

FCC Statement

This device complies with Part 15 of the FCC Rules .
Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this
device must accept any interference received, including
interference that may cause undesired operation .
This product has been tested and complies with the
specifications for a Class B digital device, pursuant to Part
15 of the FCC Rules . These limits are designed to provide
reasonable protection against harmful interference in a
residential installation . This equipment generates, uses,
and can radiate radio frequency energy and, if not installed
and used according to the instructions, may cause
harmful interference to radio communications . However,
there is no guarantee that interference will not occur in
a particular installation . If this equipment does cause
harmful interference to radio or television reception, which
is found by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment
and devices
• Connect the equipment to an outlet other than
the receiver's
• Consult a dealer or an experienced radio/TV technician
for assistance
FCC Caution: Any changes or modifications not expressly
approved by the party responsible for compliance could
void the user's authority to operate this equipment .
IEEE 802 .11b or 802 .11g operation of this product in the
USA is firmware-limited to channels 1 through 11 .
The device for the band 5150-5250 MHz is only for indoor
usage to reduce the potential for harmful interference to
co-channel mobile satellite systems .

Mexico Regulatory Statement

La operación de este equipo está sujeta a las siguientes
dos condiciones: (1) es
dispositivo no cause interferencia perjudicial y (2) este
equipo o dispositivo debe aceptar cualquier interferencia,
incluyendo la que pueda causar su operación no deseada .
EAC Mark of Conformity for Russia,
Kazakhstan and Belarus
posible que este equipo o
Wireless Regulatory Information
FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure
limits set forth for an uncontrolled environment . This
equipment should be installed and operated with minimum
distance 32 cm between the radiator and your body .
This device and it's antennas(s) must not be co-located
or operating in conjunction with any other antenna
or transmitter except in accordance with FCC multi-
transmitter product procedures .
Industry Canada Statement
CAN ICES-3 (B)/NMB-3 (B)
Under the Industry Canada Statement: This device complies
with Industry Canada license-exempt RSS standard(s) .
Operation is subject to the following two conditions: (1) This
device may not cause interference, and (2) this device must
accept any interference, including interference that may
cause undesired operation of the device .
For product available in the USA/Canada market, only
channel 1~11 can be operated . Selection of other channels
is not possible .
The device could automatically discontinue transmission in
case of absence of information to transmit, or operational
failure . Note that this is not intended to prohibit transmission
of control or signaling information or the use of repetitive
codes where required by the technology .
Industry Canada Radiation Exposure
Statement
This equipment complies with IC radiation exposure limits
set forth for an uncontrolled environment . This equipment
should be installed and operated with minimum distance
32 cm between the radiator & your body .
This device and it's antennas(s) must not be co-located
or operating in conjunction with any other antenna or
transmitter except in accordance with IC multi-transmitter
product procedures .
Restrictions in the 5 GHz Band
The device for the band 5150-5250 MHz is only for indoor
usage to reduce potential for harmful interference to co-
channel mobile satellite systems .
This device has been designed to operate with an antenna
having a maximum gain of 1 .72 dBi and 2 .52 dBi at 2 .4
GHz and 5 GHz respectively . Antenna having a higher gain
is strictly prohibited per regulations of Industry Canada .
The required antenna impedance is 50 ohms .
The maximum antenna gain (Please see the table below)
permitted (for devices in the bands 5250-5350 MHz
and 5470-5725 MHz) to comply with the EIRP limit and
because high power radars are allocated as primary users
(meaning they have priority) in 5250-5350 MHz and
5650-5850 MHz, these radars could cause interference
and/or damage to license exempt LAN devices .
1