Initial Setup - GrowMax Water MAXQUARIUM 000PPM Manual De Instrucciones

Initial Set Up:
Depending where you want to install the system, you have the option
of using one of the three inlet connectors included in the system.
1. Push in the 3/8" white inlet tubing into the 3/8" fitting on the filter housing
on the right side of the system.
2. Connect the 1/4" blue purified water tubing to the outlet of the Automatic
Shut-off valve.
3. Connect the 1/4" black waste water tubing to the outlet of the flow restrictor.
You are now ready to connect the other end of the 3/8" inlet tubing to your inlet
water connector.
Upon initial start up of system, slowly turn the source water on until the carbon,
sediment, and deionization filters have water in the housings. Next, open source
water up all the way (do not exceed 80 psi). Flush the system for 15 minutes
when the system is new and/or when you replace your membrane.
Note:
It may take up to 24 hours of running the system for the PPM & pH of the
purified water to stabilize.
How to Connect and Disconnect
Tubing to Quick Connect Fittings:
Push tube firmly into the fitting connector all the way to until the tube stops.
Try to pull the tube out to check the security. If the tube pulls out, then push
all the way in again.
To disconnect the tubing. First make sure the system is de-pressurized by
turning off inlet water. Push in the "collet" that holds the tube into the fitting
connector. While pushing in the collet you can now simply pull out the tubing.
Push in Collet
Remove Tube