Important Installation Information; Tools Needed For Installation Of Anti-Tip Device - Thermador Professional PRO-HARMONY PRG30 Serie Manual De Instalación

reengaged when the range is pushed back
against the wall. In the event of abnormal
usage (such as a person standing, sitting,
or leaning on an open door), failure to take
this precaution can result in tipping of the
range. Personal injury might result from
spilled hot liquids or from the range itself.
WARNING —
HAZARD
• Use extreme caution when drilling holes
into the wall or floor. There may be con-
cealed electrical wires located behind the
wall or under the floor.
• Identify the electrical circuits that could be
affected by the installation of the Anti-Tip
Device, then turn off power to these cir-
cuits.
• Failure to follow these instructions may
result in electrical shock or other personal
injury.
WARNING:
• All Ranges can tip.
• Injury to Persons could result.
• Install Anti-Tip Device packaged
with range.
• Verify that the anti-tip device is
engaged.
• See Installation Instructions.
ATTENTION — PROPERTY DAMAGE
• Contact a qualified installer or contractor to determine
the proper method for drilling holes through the wall or
floor material (such as ceramic tile, hardwood, etc.)
• Do not slide the range across an unprotected floor.
• Failure to follow these instructions may result in
damage to wall or floor coverings.
Tools Needed for Installation of Anti-Tip
Device:
• Screwdriver, Phillips
• Drill, electric or hand
• Measuring tape or ruler
• 1/8" drill bit (wood or metal wall or floor)
• 3/16" carbide-tipped masonry drill bit (concrete or
concrete block wall or floor)
English 10
ELECRICAL SHOCK
• 3/16" anchors, drywall or concrete, 4 each (not
required if mounting bracket is being attached to solid
wood or metal)
• Hammer
• Pencil or other marker
30" and 36" Ranges
See Figure 7 and Figure 8.
Thermador
Qty
Service Part No.
415078
647936

Important Installation Information:

• The anti-tip bracket may be attached to a solid wood
cabinet having a minimum wall thickness of 3/4".
• The thickness of the wall or floor may require use of
longer screws, available at your local hardware store.
• In all cases, at least two (2) of the bracket mounting
screws must be fastened to solid wood or metal.
• Use appropriate anchors when fastening the mounting
bracket to any material other than hard-wood or metal.
Note:
48" Ranges do not require the Anti-Tip Bracket. This is due
to the size and weight distribution of the 48" models.
Description
Screw, Phillips,
4
#10 x 1-1/2"
Anti-Tip Bracket,
1
Floor-Mounted
Figure 7: Anti-tip Bracket