Intended Use - AEG SRR 4319 Instrucciones De Servicio

English
52
22 Function selector switch
(CD/MP3/USB/SD/TAPE/RADIO)
23 PLAY/PAUSE/USB/SD button
(Play/Pause)
24 SKIP- button (reverse search)
25 VOL (volume control)
26 SKIP+ button (forward search)
27 AC Mains connection
28 LCD display
29 IR Sensor for the remote control
30 FM.ST control lamp
31 Loudspeaker
32 Battery compartment
33 Cassette compartment

Intended Use

This device is used for:
• The reception of radio programmes
• Playing back/recording audio cassettes
• Playing back audio/MP3 CDs.
It is intended exclusively for this purpose and may only
be used as such. It may only be used in the manner
described in these instructions for use. The device must
not be used for commercial purposes.
Any other use of this device is considered to be contrary
to the intended use and may result in damage to materi-
als or even personal injury.
The fi rm ETV – Elektro-Technische Vertriebsgesellschaft
mbH does not accept any liability for damage caused as
a result of the use of this device contrary to its intended
use.
Start-up of the device/introduction
• Please read the operating instructions carefully
before using the device for the fi rst time!
• Select a suitable location for the device, such as
a dry, fl at, non-slip surface on which it is easy to
operate the machine.
• Ensure that the device is suffi ciently ventilated!
• Remove the protective fi lm from the display if it is
still present.
Power Supply
• Connect the power cable supplied (see battery
compartment if necessary (32)) to a properly installed
230 V / 50 Hz safety power socket and the mains
connector AC ~ (27) on the back of the machine.
• Ensure that the voltage is the same as that indicated
on the model identifi cation plate.
Setting the Time (in standby mode)
• Keep the TIMER button (11) pressed down.
• Press the HOUR button (10) in order to set the hours.
Keep the button pressed down until the desired hour
is reached.
05-SRR 4319 CD_MP3.indd 52 05-SRR 4319 CD_MP3.indd 52
• Press the MIN button (9) in order to set the minutes.
Keep the button pressed down until the desired
minutes are reached.
• The time is stored automatically.
NOTE:
Storage/display of the time is lost as soon as the
electricity supply is interrupted. If you would also like
to be able to read the time in standby mode, please
insert 2 batteries (UM2/R14 1.5 V) in the battery
compartment on the underside (not supplied). Open
the lid of the battery compartment on the bottom.
Inserting the Batteries (not supplied)
• Open the lid of the battery compartment (32) on the
bottom.
• Insert 8 batteries of type UM2/R14 1,5V. Please en-
sure that the polarity is correct (see the fl oor of the
battery compartment)!
• If the device is not used for a long period of time, re-
move the batteries to avoid the spilling of battery acid.
• Then close the battery lid.
NOTE:
When a mains cable is connected the batteries are
automatically switched off .
CAUTION:
• Diff erent battery types or new and used batteries
must not be used together.
• Batteries are not to be disposed of together with
domestic wastes. Dispose of the used batteries at
the relevant collection bin or at your dealer's.
WARNING:
Do not expose the batteries to high temperatures or
direct sunlight. Never throw batteries into the fi re.
There is a danger of explosion!
Transport Safety Device, CD Compartment
• Open the CD compartment (3) by pulling the lid
upwards by the tab (8).
• Before operating the machine for the fi rst time, re-
move the transport safety device from the CD player
if it is still in place.
Volume
The desired volume can be sent using the VOL / regulator
(25).
14.01.2008 10:25:40 Uhr 14.01.2008 10:25:40 Uhr