Certification - Inexq ISW054t Guía Inicio Rápida

Regulatory Standards Compliance
EMI Certification
FCC Class B Certification(USA)
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in
a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct ther interference by one or more of the following
measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
The antenna(s) used for this transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.
Shielded interface cables must be used in order to comply with emission limits.
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. In order to avoid the possibility of exceeding the FCC radio
frequency exposure limits, human proximity to the antenna shall not be less than 20cm
(8 inches) during normal operation.
You may use unshielded twisted-pair (UTP) for RJ-45 connections Category 3 or greater
for 10 Mbps connections, and Category 5 for 100 Mbps connections.
CE Mark Declaration of Conformity
This is to certify that the product complies with ISO/IEC Guide 22 and EN45014. It
conforms to the following specifications:
14