Safety Instructions - Faro FS1010 Istrucciones De Uso

1 Safety instructions

Read the following safety instructions before switching on the sealer.
Legend:
Read user manual
CAUTION! Danger of electric shock.
Our products have left the factory safety-related flawless condition
To preserve this condition, the following safety instructions and type label, markings, safety
instructions on the sealer should be observed or else persons could be endangered or this
product itself or other equipment could be damaged.
These safety instructions have been established on the basis of European Directives about the
safety of electric equipment. Follow national provisions if different from the mentioned
standards.
If these safety instructions are not sufficient, the manufacturer can be contacted at the address
included in the product label.
 Please check the package and claim damages immediately to the transport company.
 Before using the sealer ensure that the sealer has no damages. In doubt ask electrical
trained staff or contact us under the address below.
 Before using the sealer please check if the voltage of the device comply with the
current of your country. The fuse beside the power switch must be adapted to the
power supply. At 115V: T8A, at 230V: T4A. The sealer is supplied with a T4A fuse.
 The sealer must only be connected with the supplied power cord to a grounded socket.
It is not allowed to be connected to an IT power supply.
 Put the device on a stable surface.
 If the sealer is transported from a cold into a warm environment, it is possible that
there will be some condensation. Wait until the temperature is equalised. There is
danger for life, if the device is put into operation when there is any condensation!
 Only authorised staff is allowed to exchange fuses and carrying out repairs. Please
contact the address below.
Istruzioni d'uso/Instructions for use/Mode d'emploi/Istrucciones de uso
Automatic Sealer/Sigillatrice automatica FS 1010 – Rev.00
.
11