Installing The Cover; Configuring The System Software; Entering And Exiting Configuration Mode; Setting The Low Voltage Shut-Down - Dometic COOLAIR RTX 1000 Manual De Instalacion Y Uso

Parking Cooler

7 .4 Installing the Cover

18 Installing the Cover
Cover
q
10 x 48 Spacer
w
1. From inside the vehicle, place the eight 10 x 48
spacers into the four cover mounting locations.
2. Place the cover over the mounting brackets and the
roof opening.
3. Insert the four M6 x 100 screws and the four M6
washers into the four mounting locations in the cover
and tighten the screws. The maximum allowable
torque for M6 x 100 screw is 35 in. lbs (4 Nm).
The cover should be flush with the roof of the
I
vehicle when installed.
8 Configuring the System
Software
Before the system is first operated, the system settings
can be adjusted to suit the various installation conditions.
These adjustments must be made by the installer.
EN
w
q
e
r
M6 Washer
e
M6 x 100 Screw
r
Indication
Display
Parameter
Low voltage
P.01
Shut-Down
Unit for
P.02 temperature
display
I Configuration mode can still be activated if the low
voltage cut-out has switched off the system and
only the residual voltage is available.
8 .1 Entering and Exiting
Configuration Mode
1. Refer to "Understanding the Controls" on page 14
for a list of buttons and button functions.
2. Press and hold the List button.
3. Press and hold the On/Off button for longer than
three seconds.
4. The parking cooler switches to CONFIGURATION
mode. The display shows "P.01" and the battery
symbol flashes.
5. Press the Up or Down button to scroll through the
menu to select the desired menu item.
6. Press the List button to open the desired menu item.
7. Press and hold the On/Off button for longer than
three seconds to exit CONFIGURATION mode.
8 .2 Setting the Low Voltage Shut-
Down Voltage - P .01
The battery monitor protects the battery against
discharging excessively.

Configuring the System Software

Factory
Meaning
Setting
The battery
monitor shuts
Down the
11.4 V
system at the
factory setting

voltage.

The temperature
can be
°F
displayed in
°C or °F.
13