BEAUTURAL 719UK-0003 Manual De Instrucciones página 5

EN 3. Round Sapphire Grinder
Removes corns.
DE
• When removing a layer of skin from the corn, you
FR
will quickly penetrate deeper into the skin and
ES
could injure the periosteum.
IT
4. Needle-shaped Grinder
Remove dead skin.
• This is a precision tool, so proceed cautiously
when using this attachment. This attachment frees
ingrown nails and cuts away parts of dead nails. Use
only at low speed.
5. Mandrel
Holds sanding bands.
6. Sanding Band
Removes dry skin and foot calluses and treats nails.
• Sanding bands can be removed and discarded
after a single use. Ten single-use sanding bands are
included. To maintain natural skin protection, do not
completely remove calluses.
7. Flame Milling Cutter
For removing ingrowing nails.
• Guide the flame milling cutter carefully onto the
treatment area and cut away the affected nail part.
8. Cylindrical Milling Cutter
For grinding and smoothing thickly-grown toenail
surfaces.
• Apply the milling cutter horizontally to the nail
surface and remove the unwanted layer of nail
using slow circular movements. Apply light pressure.
6
9. Hardened Skin Remover
For removing large-scale and thick hardened skin or
calluses on the soles and heels of the feet.
• Guide the hardened skin remover attachment over
the parts of the sole and heel to be treated. Exert
gentle pressure. Note that it is not recommended
to remove too much skin from calluses as this may
cause them to grow back much harder.
10. Sapphire Cone
For removing thick or large calluses on the soles and
heels. This attachment is intended for large areas.
• Guide the sapphire cone over the parts of the
sole and heel to be treated. Use a circular motion
while applying gentle pressure. Apply moisturizing
cream after every treatment. Note that it is not
recommended to remove too much skin from
calluses as this may cause them to grow back much
harder.
11. Felt Cone
For both smoothing and polishing nail edges after
filing and for cleaning nail surfaces after grinding.
• Polish with the felt cone using a circular motion.
Never polish in a single place without continuous
movement across the nail's surface as friction will
cause a large amount of heat to develop.
EN
DE
FR
ES
IT
7