Gima ASTRA Manual De Uso Y Mantenimiento página 6

To calibrate the scale, after setting both weights to zero, work on the adjustment screws (see
illustration) until the indicator matches the measurement tab.
The base must be positioned on a perfectly flat floor to calibrate the unit correctly.
OPERATION
Before the person steps onto the platform, bring the height cursor up above the person's height.
After the person is on the platform, slowly lower the cursor until it rests on the person's head.
The graduated measuring beam can be extended on both sides: the lower part can be used to
measure heights up to 102 cm. The height value is indicated right by the cursor. The upper ruler
is used to measure heights up to 200 cm. The height value is indicated right where the two
graduated measuring beams intersect, indicated by the READ arrow (see illustration).
Note: to correctly use the upper measuring beam block the cursor on the upper part of the
sliding measuring ruler.
Attention: Do not keep the cursor horizontally because it may be dangerous.
MAINTENANCE
The device was designed to last a lifetime. It is resistant to chemical attack, except for M.E.K.
ketons, diluting solutions and polish removers.
Periodically verify the calibration and the leveling of the scale. Perform this operation
every time it is moved (see installation).
GIMA WARRANTY CONDITIONS
Congratulations for purchasing a GIMA product.
This product meets high qualitative standards both as regards the material and the production.
The warranty is valid for 12 months from the date of supply of GIMA.
During the period of validity of the warranty, GIMA will repair and/or replace free of charge all the
defected parts due to production reasons. Labor costs and personnel traveling expenses and
packaging not included.
All components subject to wear are not included in the warranty.
The repair or replacement performed during the warranty period shall not extend the warranty.
The warranty is void in the following cases: repairs performed by unauthorized personnel or
with non-original spare parts, defects caused by negligence or incorrect use.
GIMA cannot be held responsible for malfunctioning on electronic devices or software due to
outside agents such as: voltage changes, electro-magnetic fields, radio interferences, etc.
The warranty is void if the above regulations are not observed and if the serial code (if available)
has been removed, cancelled or changed.
The defected products must be returned only to the dealer the product was purchased from.
Products sent to GIMA will be rejected.
ENGLISH 6