Publicidad
Idiomas disponibles
Idiomas disponibles
Quality Tools for Smart Cleaning
Thank you for your purchase of the Unger HiFlo Soap Dispenser.
This guide will help you get setup and using your system right away.
1. Start-up
This soap dispenser is powered by water flow. No external power is
required. Just include it into the water flow (see arrows on the dis-
penser) between the pure water filter and your water fed pole
to support the cleaning of heavy soiled glass and surfaces.
1.1 Content and Connection
The soap dispenser is delivered ready to use, including a
hose connection. To fix it at a purewater filter, please use
the separate Connection Kit # HCDCK
1.
Fix the belt at the black bracket and fix that at the purewater
filter. Pay attention that no parts of the filters are squeezed.
2.
Press the dispenser onto the bracket. The nipples must click
into the holes in the side of the bracket.
3.
Now connect the water outlet hose from the purewater filter
with the Water-In of the dispenser. Loosen therefor the connection
at the water outlet line.
4.
Connect the hose from the connection kit between Water-Out of
the dispenser and water out of the filter.
(In case the hoses are too short you can also turn the dispenser in
the bracket, but always pay attention of the correct flow direction,
displayed by the arrows.
5.
Fix the thin hose at the bottom of the dispenser.
The other end place in a soap bottle or canister.
6.
The mix ratio or the soap can be switched on/off with the
black knob (6) on the dispenser (Bypass function).
1.2 Adjust soap mix ratio
1.
Remove the upper black latch.
ATTENTION: The lower latch must always stay in the dispenser!
As this one is responsible for mixing the soap ration.
2.
Turn the grey adjustment sleeve to the desired % value, to receive
the wanted mixing ratio.
3.
Fix this ratio with the upper latch.
8
HiFlo Soap Dispenser
Quick Start Guide
www.ungerglobal.com
On/Off
Motor
Water In
Water Out
Dosing
Suction tube
Beispiel:
6
Publicidad
