Getting Started; Powering On/Off; Powering On With Emergency Key; Powering On With Transmit Inhibit Active - Eads TGR990 Manual De Utilización

1. Getting started

Powering On/Off

To power On, press and hold the rotary knob
performs a self-check and registration routine. After successful
registration, the TGR990 is in service.
To power Off, press and hold the rotary knob push key. You hear a
beep.

Powering On with Emergency key

Press and hold
Emergency Mode or in standard mode (as programmed).

Powering On with Transmit Inhibit active

Transmit Inhibit (TXI) is a feature allowing you to switch off
transmission before entering a Radio-Frequency (RF) sensitive
area. To activate this feature, press the menu key
Setup→Networks→TXI
Warning: Pressing
causes the TGR990 to transmit immediately. The TGR990 must
NOT be within the RF sensitive area when entering Emergency
Mode.
The TXI Mode remains active at power On. You are prompted
whether to leave the TXI Mode On or not.
Warning: Ensure you have left the RF sensitive area before
deactivating Transmit Inhibit.
Press the Yes soft key to deactivate the TXI Mode. If the TGR990
was previously used in Trunked Mode, it will register to the network.
If the TGR990 was previously used in Direct Mode, it will remain in
Direct Mode.
to power On. The TGR990 powers On in
Mode→Activate.
, even if Transmit Inhibit is activated,
G e t t i n g s t a r t e d
. The TGR990
and select
MENU
15
E
N
G
L
I
S
H
D
E
U
T
S
C
H
F
R
A
N
Ç
A
I
S
S
V
E
N
S
K
A
E
S
P
A
Ñ
O
L
N
E
D
E
R
L
A
N
D
S
P
O
L
S
K
I