On A Macintosh Computer - Brother P-Touch 2600 Guía De Usuario

On a Macintosh Computer

The Mac version of the software is for a Macintosh with an English operating system. If the
software is installed on a Macintosh with an operating system in a different language, the soft-
ware may not run properly.
BEFORE INSTALLATION
Check that your system configuration meets the following requirements.
Computer: Macintosh with a Power PC processor
Operating system: Mac OS 8.6 to 9.X or OS X 10.1 to 10.2.1
Hard disk free space: At least 20 MB (100 MB to install full option)

Up to 100 MB of hard disk free space may be needed when printing long labels or large
amounts of data.
Memory: At least 32 MB of available RAM
USB port (installed as standard equipment)
CD-ROM drive
* The application is supplied on a CD-ROM; therefore, the computer should be equipped
with a CD-ROM drive.
INSTALLING THE P-TOUCH EDITOR 3.2 SOFTWARE
The P-touch Editor 3.2 software includes a variety of more complex functions for printing bar-
codes and images, enabling you to design just about any label that you can image. Install the
P-touch Editor 3.2 software onto a Macintosh as described below.
With a Mac OS before OS X:
1 With the P-touch 2600/2610 and the Macintosh turned off, connect the P-touch to the
computer using the enclosed USB interface cable as described on page 6. Be sure to
leave the P-touch turned off.
2 Turn on the Macintosh.
3 Insert the enclosed CD-ROM into the com-
puter's CD-ROM drive.
4 Double-click the Mac OS 9 folder to open
it.
23