Wiring Conventional Systems: Forced Air And Hydronics - Honeywell Home Pro Serie Instrucciones Para La Instalación

Wiring conventional systems: forced air and hydronics

Shaded areas below apply only to TH6320U/TH6220U or as otherwise noted.
1H/1C System (1 transformer)
R Power [1]
Rc [R+Rc joined by Slider Tab] [2]
Y
Compressor contactor
C 24VAC common [3]
W
Heat relay
G
Fan relay
Heat-only System
R Power [1]
Rc [R+Rc joined by Slider Tab] [2]
C 24VAC common [3]
W
Heat relay
Heat-only System (Series 20) [5]
R Series 20 valve terminal "R" [1]
Rc [R+Rc joined by Slider Tab] [2]
Y
Series 20 valve terminal "W"
C 24VAC common [3]
W Series 20 valve terminal "B"
Heat-only System
(power open zone valve) [5]
R Power [1]
Rc [R+Rc joined by Slider Tab] [2]
W
Valve
C 24VAC common [3]
NOTES
Wire specifications: Use 18- to 22-gauge thermostat wire. Shielded cable is not required.
[1]
Power supply. Provide disconnect means and overload
protection as required.
[2] Move R-Slider Tab on UWP to the R setting. For more
information, see "Setting Slider Tabs" on page 3
[3] Optional 24VAC common connection.
1H/1C System (2 transformers)
R Power (heating transformer) [1]
Rc Power (cooling transformer) [1]
Y
Compressor contactor
C 24VAC common [3, 4]
W
Heat relay
G
Fan relay
Heat-only System with Fan
R Power [1]
Rc [R+Rc joined by Slider Tab] [2]
C 24VAC common [3]
W
Heat relay
G
Fan relay
Cool-only System
R Power [1]
Rc [R+Rc joined by Slider Tab] [2]
Y Compressor contactor
C 24VAC common [3]
G Fan relay
2H/2C System (1 transformer) [6]
R Power [1]
Rc [R+Rc joined by Slider Tab] [2]
Y Compressor contactor (stage 1)
C 24VAC common [3]
W Heat relay (stage 1)
G Fan relay
W2 Heat relay (stage 2)
Y2 Compressor contactor (stage 2)
[4]
Common connection must come from cooling transformer.
[5] In ISU set Heat system type to Radiant Heat. Set number of
cool stages to 0.
[6] In Installer Setup, set system type to 2Heat/2Cool
Conventional.
4